USING COMPASS WITH A USB TO SERIAL CONVERTER
THIS DOC USES THE BELKIN F5U103 USB SERIAL ADAPTER
ONLY
THE BELKIN F5U103 will only work, using a direct connect with the
4100SM. ADEMCO has been unable to test and pass this unit when using
with a serial modem.
Secondly, Ademco will only advise to how this process should work, and be
wired. ADEMCO does not, guarantee, USB to SERIAL devices to be fully
functional.
The drivers for this device, emulate a COM port, as seen below (NOTICE: FOR
USE WITH COMPASS YOU MUST EMULATE ONLY THE FOLLOWING COM PORTS (1,2,3,or 4).
Notice, that the drivers installed, are now emulating a COM 3.Once
emulation, does take place, assign a modem in COMPASS to the COM port
being emulated, and follow the direct connect instructions from here.
">
