ALC AHSS31 Quick Start Guide
Add to my manuals
2 Pages
ALC AHSS31 is a motion detector that can be used to enhance the security of your home. It is compatible with ALC AHS613, AHS616, and AHS629 Security Systems. The detector has a 110-degree detection angle and can be mounted on a wall or in a corner. It is also easy to set up and use. Simply download the Connect App, install the ALC Control Hub, and follow the on-screen instructions to pair the detector with the hub. Once paired, you can control the detector from the app, as well as access the Scenario, Event, and Setting screens.
advertisement
u v
Operation
When first turning on the app you will enter the Control Hub (or
System Name you gave) Selection window. Simply tap your
Control Hub to enter.
The Status screen will appear. Here you can control the connected devices as well as access the Scenario, Event and
Setting’s screens.
ACCESSORY
Compatible with ALC AHS613, AHS616, and
AHS629 Security Systems
Motion Detector
Quick
Quick
Simple
Set Up
For detailed installation and setup and to view the ALC 1 Year
Limited Warranty, please refer to the complete Connect Series
User’s Guide available on our website: www.ALCWireless.com/support
SCAN
TO VIEW
COMPLETE
USER’S GUIDE
Model: AHSS31
QUICK START GUIDE
Please read these instructions completely before operating this product.
A
B
Installation
For first time use, batteries are pre-installed (3 AA batteries 3).
Apply the double-sided tape to the rear of the Motion Detector as shown. Use the thick tape for flat wall mount or the thin table for corner mounting. Select a location between 2-2.5 meters (6-8 ft) from the floor.
50 feet
110 degrees detection angle
6 to 8 feet
This Motion Detector is an accessory to be used along with the
Connect series Control Hub Kit. Please refer to this quick start guide as well as the Connect series owner’s manual, see back cover for details.
Pairing
IMPORTANT: This device needs to be paired with the Control
Hub as follows.
u Since this device is an added accessory, you should have downloaded the Connect App and installed the ALC Control
Hub as described in the Connect Series owner’s manual. v B
+.
A w Remove the insulating plastic tab then open the detector by pressing the tab at the bottom. Press the Pair button.
x Tap Motion Detector. Tap Pair and follow the on screen instructions.
At the final screen, enter the Motion
Detector’s name and location and tap
Save.
Trouble Pairing?
If it did not detect the detector, remove the battery for 5 seconds and press the Pair button again. Repeat step 4.
50 feet
110 degrees detection angle
6 to 8 feet
advertisement
* Your assessment is very important for improving the workof artificial intelligence, which forms the content of this project
Related manuals
advertisement