Rowlinson CG095 Owner Manual

5ft Picnic Bench
ROWLINSON GARDEN PRODUCTS LIMITED
Green Lane
Wardle, Nr. Nantwich
Cheshire. CW5 6BN
Help Line (Normal Office Hours): 01829 261 121
Email: [email protected]
Website: www.rowgar.co.uk
English SS275A
Assembly Instructions
1. Leg to seat support
3. Table
Bolt the legs as shown to the seat supports using 2 x75mm bolts nuts and
washers per leg. Push the bolts through the pre-drilled holes, on the thread
end place a washer and then add the nut and tighten.
Position the table on the top of the legs centrally with the table framing on the
inside of the legs. secure in place using 2 x 60mm screws per leg. Screw
through the leg into the table frame.
60mm
75mm
Washer
Nut
Biocidal Products
Regulation EU 528/2012
Wolmanit® CX treated wood is a treated article that incorporates biocidal products: copper hydroxide
carbonate/II/ and boric acid. They protect wood against fungal decay /rot/ and insect attack.
Keep away from food, drink and animal feeding stuffs. Avoid breathing dust when cutting treated wood.
Washer
Nut
Before assembly
60mm
• We recommend that time is taken to read the instructions before
Washer
starting assembly, then follow the easy step by step guide.
The instruction sheet is only a guide to the assembly.
Certain items may not be shown to scale.
• Check all components prior to assembly
• Drill all components where indicated.
• This product should be assembled by no less than two people.
• Never attempt to erect the assembly in high winds.
x2
Washer
2. Seats
Position the seats on top of the seat supports as shown. Have the seat framing
on the inside of the supports and the seats flush to the ends of the supports.
Secure the seats in place using 2 x 60mm screws at each seat end, screw
through the seat support into the frame of the seat.
Drill pilot holes in the seat frames for each
screw using a 3mm drill bit.
Drill
Recommended tools for assembly
• Cross head screw driver
• Drill with 3mm diameter drill bit
• 13mm spanner
No.
1
2
3
4
5
6
Components
Leg
Seat support
Seat
Table top
Table support
Brace
No.
Fixing Kit
Qty.
7
8
9
10
75mm bolt
Washers
Dome nuts
60mm screws
8
8
8
26
Secure the table supports to the legs just under the table top as shown using
2 x 60mm screw per support. Position each brace under the centre of the table
as shown and secure through the seat support into the end of the brace using
2 x 60mm screws. Then screw 1 x 60mm screw through other end of the brace
into the underside of the table.
Drill
60mm
Qty.
4
2
2
1
2
2
4. Table supports and braces.
75mm
60mm
60mm
60mm
4
6
IMPORTANT: RETAIN FOR FUTURE REFERENCE
READ CAREFULLY
5
Periodically check all fastenings for tightness
For contract and domestic use
2
1
3
60mm
We constantly improve the quality of our products, occasionally the
components may differ from the components shown and are only
correct at time of printing. We reserve the right to change the
specification of our products without prior notice.
2015 © Rowlinson Garden Products Ltd