Resetting your TWS
In boot state, touch R/L 8 times and put them into
the charging case and close lip to reset TWS.
USER MANUAL
FUNCTIONS
Power on
1.Remove your earbuds from the charging
case to auto Power On.
2.Or touch the R or L earbud for 5 seconds to
Hear a prompt tone.
Power Off
1.Place your earbuds back into the charging
case
2.Or touch the R or L earbud for 4 seconds
to hear a prompt tone.
Answer
Touch R or L 2 times
End Call
Touch R or L 2 times
CHARGING
(Be sure fully charge the TWS before using
for the first time)
Charging the case:
Low battery indication: the WHITE LED
light on the bottom of the case flashes
quickly.
Plug the Type-c cable into the bottom of
the case to charge it.
The breathing LED will light green while
charging. Once fully charged, LED will
be in solid green.
Charging the earbuds:
Place the earbuds into their respective slots
in the charging case.
The breathing LED light will light white
while charging.
Rejecting a call
Touch and hold R or L earbud 2 seconds
until hear a prompt sound
Play/Pause
Touch R or L earbud 2 times
BLUETOOTH PAIRING INSTRUCTION
1. Open charging case, L/R earbuds will
begin to auto-pairing to each other. You
will hear a prompt tone t o confirm a
successful pairing.
2.Keep the earbuds within 3 feet of your
smart device (for Bluetooth pairing only).
Enable your device’s Bluetooth function
from your device’s settings menu. Select
“RT67” from the Bluetooth device list to pair
the earbuds to your device.
3.You will hear a prompt tone indicating that
TWS are now ready to use.
4.Each earbud can be used independently.
Next song
Touch R earbud 3 times
Previous song
Touch L earbud 3 times
Summoning Siri
Touch and hold L earbud 2 seconds until
hear a prompt sound
Gaming mode
Touch and hold R earbud 2 seconds until
hear a prompt sound
ENC function
Environment noise canceling function will be
automatically activated while user in calling.
尺寸：50*110mm
材质：80G书写纸 双面印刷 十字对折
SPECIFICATIONS
Input
Battery capacity
5V-700mA
90mAhx2(earbuds);
1000mAh(charging case)
Playtime (Varies by volume) 11 hours(totally 50+
hours with the charging
case)
Frequency response
Bluetooth version
Bluetooth range
20Hz-20KHz
V5.3
10m/33ft50
Bluetooth chipset
BES2600
ATTENTION
1. Don’t expose to liquids
2. For AC/DC Adapter, the socket-outlet shall
be installed near the equipment and
shall be easily accessible. We
recommend users charge this TWS with
DC 5V/700mA adaptor.
3. To prevent possible hearing damage,
do not listen at high volume levels of
long periods.
4. There are no restriction of use
This device complies with Part 15 of the FCC Rules. Operation is
subject to the following two conditions: (1) this device may not
cause harmful interference, and (2) this device must accept any
interference received, including interference that may cause
undesired operation.
Changes or modifications to this unit not expressly approved by
the party responsible for compliance could void the user’s authority
to operate the equipment.
NOTE: This equipment has been tested and found to comply with
the limits for a Class B digital device, pursuant to Part 15 of the
FCC Rules. These limits are designed to provide reasonable
protection against harmful interference in a residential installation.
This equipment generates uses and can radiate radio frequency
energy and, if not installed and used in accordance with the
instructions, may cause harmful interference to radio
communications. However, there is no guarantee that interference
will not occur in a particular installation. If this equipment does
cause harmful interference to radio or television reception, which
can be determined by turning the equipment off and on, the user is
encouraged to try to correct the interference by one or more of the
following measures:
-- Reorient or relocate the receiving antenna.
-- Increase the separation between the equipment and receiver.
-- Connect the equipment into an outlet on a circuit different from
that to which the receiver is connected.
-- Consult the dealer or an experienced radio/TV technician for
help.
This device and its antenna(s) must not be co-located or operation
in conjunction with any other antenna or transmitter.
Radiation Exposure Statement
The device has been evaluated to meet general RF exposure
requirement in portable exposure condition without restriction.
Made In China
">
