TC22 Touch
Computer
Quick Start Guide
ZEBRA and the stylized Zebra head are trademarks of Zebra Technologies Corporation, registered in many
jurisdictions worldwide. All other trademarks are the property of their respective owners. ©2022 Zebra
Technologies Corporation and/or its affiliates. All rights reserved.
Information in this document is subject to change without notice. The software described in this document
is furnished under a license agreement or nondisclosure agreement. The software may be used or copied
only in accordance with the terms of those agreements.
For further information regarding legal and proprietary statements, please go to:
SOFTWARE: zebra.com/linkoslegal.
COPYRIGHTS: zebra.com/copyright.
WARRANTY: zebra.com/warranty.
END USER LICENSE AGREEMENT: zebra.com/eula.
Terms of Use
Proprietary Statement
This manual contains proprietary information of Zebra Technologies Corporation and its subsidiaries
(“Zebra Technologies”). It is intended solely for the information and use of parties operating and
maintaining the equipment described herein. Such proprietary information may not be used, reproduced,
or disclosed to any other parties for any other purpose without the express, written permission of Zebra
Technologies.
Product Improvements
Continuous improvement of products is a policy of Zebra Technologies. All specifications and designs are
subject to change without notice.
Liability Disclaimer
Zebra Technologies takes steps to ensure that its published Engineering specifications and manuals are
correct; however, errors do occur. Zebra Technologies reserves the right to correct any such errors and
disclaims liability resulting therefrom.
Limitation of Liability
In no event shall Zebra Technologies or anyone else involved in the creation, production, or delivery of the
accompanying product (including hardware and software) be liable for any damages whatsoever (including,
without limitation, consequential damages including loss of business profits, business interruption, or loss
of business information) arising out of the use of, the results of use of, or inability to use such product, even
if Zebra Technologies has been advised of the possibility of such damages. Some jurisdictions do not allow
the exclusion or limitation of incidental or consequential damages, so the above limitation or exclusion may
not apply to you.
2
This section lists the features of the TC22 touch computer.
Figure 1 Front and Side Views
3
Table 1 TC22 Front View
Number
1
2
3
4
5
6, 9
7
8
10
Item
Description
Front camera 8MP
Scan LED
Receiver Port
Proximity/light
sensor
Status LED
Takes photos and videos.
Indicates data capture status.
Use for audio playback in Handset mode.
Determines proximity and ambient light for controlling display backlight
intensity.
Indicates battery charging status while charging and application generated
notifications.
Initiates data capture (programmable).
Increase and decrease audio volume (programmable).
Scan button
Volume up/down
button
6 in. LCD touch
screen
PTT button
Displays all information needed to operate the device.
Typically used for PTT communications. Where regulatory restrictions
exist1, button is configurable for use with other applications.
Note 1: Pakistan, Qatar
4
Figure 2 Back, Top, and Bottom View
Table 2 TC22 Rear View
Number
Item
1
Power button
2, 5, 9
4
Microphone
Back common 8
pins
Battery release
latches
Battery
Speaker ports
6
7
8
10
11
12
13
Common IO USB
Type C and 2charge
pins
Hand strap
attachment points
ToF module
16 MP rear
camera with
flash
Description
Turns the display on and off. Press and hold to reset the device, power off or
swap battery.
Use for noise cancellation.
Provides host communications, audio and device charging via cables and
accessories.
Press to remove the battery.
Provides power to the device.
Provides audio output for video and music playback. Provides audio in
speakerphone mode.
Provides power to the device using IO USB-C interface with 2 charge pins.
Attachment points for the hand strap.
Employs time of flight techniques to resolve distance between the camera
and subject.
Takes photos and videos with flash to provide illumination for the camera.
5
Charging
Use one of the following accessories to charge the device and/or spare battery.
Charging and Communication
Description
Charging/USB Cable
1-Slot USB/Charge
Only Cradle Kit
5-Slot Charge Only
Cradle with Battery
Kit
Part Number
Charging
Communication
Remark
Spare
battery
USB
Ethernet
CBL-TC5X-USBC2A-01
CRD-NGTC5-2SC1B
Battery
(in
device)
Yes
Yes
No
No
Yes
Yes
No
No
Optional
CRD-NGTC5-5SC4B
Yes
Yes
No
No
Optional
6
Status
Off
Slow Blinking Amber
(1 blink every 4
seconds)
Solid Green
Fast Blinking Amber
(2 blinks/second)
Fast Blinking Red
(2 blinks/second)
LED
Indications
Device is not charging. Device is not inserted
correctly in the cradle or connected to a power
source. Charger/cradle is not powered.
Device is charging.
Charging complete.
Charging error, e.g.:
• Temperature is too low or too high.
• Charging has gone on too long without completion
(typically
eight hours).
Charging error but the battery is at end of useful life.,
e.g.:
• Temperature is too low or too high.
• Charging has gone on too long without completion
(typically
eight hours).
7
8
9
10
11
">
