JEGS 20490 SBC Block Protector Installation Instructions

PDF

Hati

Tangazo

Installation Instructions for 20490
SBC Block Protector
Installation Instructions:
Kit includes:
(1) Roller Thrust Bearing
(2) Bearing Race Washers
NOTE: Re-machining of the Camshaft Sprocket is needed in order to use this
block protector. This should be preformed by a qualified machinist. See Figure 1
for machining specifications and tolerances.
O.D. of step is
1.995” to 2.000”
1. Place one of the bearing race washers into the machined camshaft sprocket.
2. Clean and lubricate the roller bearing assembly with motor oil or lite grease.
3. Place the roller bearing into the washer from step one above followed by the Width of step to be
second bearing race washer.
0.135”+/- 0.005”
NOTE: Be sure camshaft end play DOES NOT exceed 0.020”. Doing so could allow
the bearing race washer to become unseated.
Figure 1
1-800-345-4545 jegs.com
">

Halo! Mimi ni chatbot ya AI iliyoandaliwa mahsusi kukusaidia na JEGS 20490 SBC Block Protector Installation Instructions. Nimepitia hati kikamilifu na ninaweza kukusaidia kupata habari kamili unayohitaji au kuelezea yaliyomo kwa maneno wazi na rahisi. Ikiwa unatafuta mwongozo juu ya huduma maalum, hatua za utatuzi, au matumizi ya jumla, jisikie huru kuuliza maswali yako. Maelezo zaidi unayotoa juu ya wasiwasi au mahitaji yako, kwa usahihi zaidi na kwa ufanisi zaidi ninaweza kukusaidia!