saver M48 Car MP3 Player Instructions

M48 Car Bluetooth Instructions
This machine is a car MP3 player that integrates Bluetooth and fast charging. Insert a cigarette
lighter and adjust the frequency point of the machine to correspond with the radio frequency
point. TF card and USB can be inserted to listen to music, and Bluetooth can also be
connected to listen to music and make calls.
Storage media: TF, USB flash drive
Input voltage: DC 12V-24V
Operation mode: button type
Display method: digital tube
Transmission interface: USB 2.0
FM emission distance: within 5M
Vehicle mounted (FM) transmission: supported, FM transmission frequency:
87.5MHz-108MHz
Mic sensitivity: -42dB
The maximum transmission distance of Bluetooth is 10 meters
Bluetooth version: V5.1
FCC Warning Statement:
This equipment has been tested and found to comply with the limits for a Class B
digital device, pursuant to part 15 of the FCC Rules. These limits are designed to
provide reasonable protection against harmful interference in a residential
installation. This equipment generates, uses and can radiate radio frequency
energy and, if not installed and used in accordance with the instructions, may
cause harmful interference to radio communications. However, there is no
guarantee that interference will not occur in a particular installation. If this
equipment does cause harmful interference to radio or television reception, which
can be determined by turning the equipment off and on, the user is encouraged to
try to correct the interference by one or more of the following measures:
•Reorient or relocate the receiving antenna.
•Increase the separation between the equipment and receiver.
•Connect the equipment into an outlet on a circuit different from that to whichthe
receiver is connected.
•Consult the dealer or an experienced radio/TV technician for help.
Caution: Any changes or modifications to this device not explicitly approved by
manufacturer could void your authority to operate this equipment.
This device complies with part 15 of the FCC Rules. Operation is subject to the
following two conditions: (1) This device may not cause harmful interference, and
(2) this device must accept any interference received, including interference that
may cause undesired operation.
The device has been evaluated to meet general RF exposure requirement.