FOOT CONTROLLER
FOR ASHFORD e-SPINNER
On/Off foot control for Ashford Electronic Spinners.
For all e-Spinners manufactured after January 2016 with a foot switch socket in the
back panel.
The e-Spinner foot switch allows you to start and stop your e-Spinner without using
your hands.
1)
Simply plug in the cord jack into the socket in the rear panel of your e-Spinner.
2)
Tap the foot controller to turn your e-Spinner on
3)
Tap the foot controller to turn your e-Spinner off
The power LED in the ON Switch shows the status of the e-Spinner.
Constant on. The e-Spinner is running OK
Flashing short on / long off. The e-Spinner is in standby, (speed set to ZERO or foot
switch OFF). Turn the power switch off if you are going to leave your e-Spinner for any
length of time.
Flashing long on / short off. The e-Spinner has a fault, (too much load or stalled motor).
Reduce the brake band tension or apply a drop of oil to the front bearing.
Ashford Handicrafts Limited
415 West Street, Ashburton 7700, New Zealand
Telephone 64 3 308 9087
[email protected] www.ashford.co.nz
Ashford Handicrafts Limited
Factory and Showroom: 415 West Street
PO Box 474, Ashburton 7700 New Zealand
Telephone 64 3 308 9087 Facsimile 64 3 308 8664
Email: [email protected] Internet: www.ashford.co.nz
FOOT CONTROLLER FOR eSPINNERS
(MANUFACTURED AFTER JANUARY 2016)
ESP2FC
9 418647 146042
ESP2FC
Batch #
Packed
Ashford Guarantee
Thank you for purchasing this Ashford product. In the unlikely event there is any fault in
manufacture, please contact the dealer you purchased it from. To validate the guarantee,
please go to www.ashford.co.nz/product-registration
">
