Ashford SampleIt Loom Stand Variable Width Instructions

SampleIt Loom Stand Variable Width
For 25cm (10") and 40cm (16") Looms
SLSV030820
Ashford Handicrafts Limited
415 West Street, P O Box 474, Ashburton, New Zealand
+64 3 308 9087
[email protected]
www.ashford.co.nz
Ashford Guarantee
Thank you for purchasing this Ashford product. In the unlikely event there is
any fault in manufacture please contact the Ashford Dealer who supplied it. To
validate our guarantee please visit our website -support - product registration,
or email us.
ASSEMBLY INSTRUCTIONS
1. If your loom is 25cm (10”) wide, use the short footrest, if
your loom is 40cm (16”) wide, use the long footrest.
2. Attach the appropriate footrest to one leg and foot as
illustrated with a 50mm (2”) bolt and barrel nut and lightly
tighten with the Hex Key. Note the tapered leg fits snuggly into
the tapered rebate in the foot. Repeat for the other side. Store
the spare rail for future use.
3. Insert the 40mm (1 ½”) round head bolts from the inside of
your loom and tap the head of the bolts flush against the loom
side. Then locate the loom and bolts into the slots in the legs
and secure with washers and knobs.
4. Sit at the loom and adjust the angle of the loom until it is
resting on your knees and the angle of the footrest to suit and
tighten the knobs.
5. Store the Hex Key in a safe place and retighten the bolts if
required.
6. Note - Support braces are optional accessories for the
SampleIt Loom Stand.
Enjoy weaving on your SampleIt Loom!
Knob
Washer
40mm(1½”) bolt
Leg
Leg
Leg
Footrest
Foot
Barrel nut
50mm (2”) bolt
Foot
Leg
Footrest
Ashford Handicrafts Limited
415 West Street, P O Box 474, Ashburton, New Zealand
+64 3 308 9087
[email protected]
www.ashford.co.nz
Foot
Foot
">