Installation Guide
IND256 | GE2029-8251
Lumination® Cable Suspension Kit
KitKIT-SUSP-YOKEM-SEMI-XXFT (95046985 / 95046986)
BEFORE YOU BEGIN
Read these instructions completely and carefully.
WARNING/AVERTISSEMENT
RISK OF ELECTRIC SHOCK
RISQUES DE DÉCHARGES ÉLECTRIQUES
RISK OF FIRE
• Follow all NEC and local codes.
RISQUES D’ INCENDIE
• Turn power off before inspection, installation or
removal.
• Properly ground electrical enclosure.
• Coupez l’alimentation avant d’’inspecter, installer ou déplacer le luminaire.
• Assurez-vous de correctement mettre à la terre le boîtier d’alimentation
électrique.
• Respectez tous les codes NEC et codes locaux.
Kit Contains:
1.
2.
3.
4.
5.
6.
Suspension cable -10’ (2x)
Toggled cross-cable (2x)
Cross-cable gripper (2x)
M6 bolt (2x)
1/4-20 cable coupler (2x)
Hourglass sleeve (2x)
LED.com
© 2023 Current Lighting Solutions, LLC. All rights reserved. Information and specifications subject to change
without notice. All values are design or typical values when measured under laboratory conditions.
Page 1 of 3
(Rev 06/26/23)
IND256_Lumination Cable Suspension Kit Installation Guide_R01
Lumination® Cable Suspension Kit
1
Installation Guide
Connect Gripper To Luminaire Mounting System
The Lower Mounting Kit is designed to connect either directly to a compatible luminaire or to a mounting bracket
included with the luminaire and provide leveling through the adjustment of the cable position.
For luminaires/mounting brackets with dual mounting holes: Connect toggled cross cable as shown and adjust position
to level. Ensure M6 bolt is tightened into gripper after levelling.
For mounting brackets with a single central hole: Remove cross cable from gripper and use M6 bolt to attach gripper
directly to bracket.
LED.com
© 2023 Current Lighting Solutions, LLC. All rights reserved. Information and specifications subject to change
without notice. All values are design or typical values when measured under laboratory conditions.
Page 2 of 3
(Rev 06/26/23)
IND256_Lumination Cable Suspension Kit Installation Guide_R01
Lumination® Cable Suspension Kit
Installation Guide
2 Connect Aircraft Cable To Ceiling Structure
The Lower Mounting Kit can connect to the ceiling structure in one of two ways:
Loop onto structure: Using hourglass sleeve loop aircraft
cable over existing building structure and pull tight. Ensure
structure is rated for luminaire load before mounting.
Couple to ¼-20 rod: Install aircraft cable through ¼-20
coupler and tighten coupler onto ¼-20 rod attached to
building structure. For finished drywall or T-grid ceilings
use KIT-MTG-UPR (93026986) to provide ¼-20 thread.
Ensure ceiling structure is rated for luminaire load
before mounting.
3 Attach Aircraft Cable To Gripper And Adjust Height
Pass aircraft cable end through hole at top of cross gripper
and pull through until desired level is reached.
Note: Height cannot be adjusted while gripper is under load.
Once mounting brackets are properly levelled luminaires can
be installed into brackets according to the specific instructions provided with the luminaire
LED.com
© 2023 Current Lighting Solutions, LLC. All rights reserved. Information and specifications subject to change
without notice. All values are design or typical values when measured under laboratory conditions.
Page 3 of 3
(Rev 06/26/23)
IND256_Lumination Cable Suspension Kit Installation Guide_R01
">
