Chapter 21
Troubleshooting and FAQs
Administration
What Dialogs Use the IOS CLI Instead of SNMP?
Q. What dialogs are retrieving or configuring information using the IOS CLI instead of SNMP?
A. In Cisco 12000/10720 v3.1.1 Router Manager some dialogs use only the IOS CLI, some use only
SNMP, and some use both IOS CLI and SNMP. Table 21-2, Table 21-3, and Table 21-4 detail each
instance.
When a dialog uses the IOS CLI, the IOS password must be set up. See Entering or Changing IOS
CLI Username and Passwords, page 4-5.
Table 21-2 Dialogs launched from Chassis objects
Dialog uses IOS CLI
(Need to set the Management
Passwords on the EM)
Dialog uses SNMP
Dialog uses IOS CLI and SNMP
(Need to set the Management
Passwords on the EM)
Configuration Editor
Chassis Configuration
SNMP Management
POS APS Status
Chassis Management Information
ATM Connection Upload
RPR Configuration
Chassis Inventory
BGP Configuration
RPR Status
Chassis Status
BGP Status
BGP Address-Family Synchronization
System Log
OSPF Status
BGP Address-Family Configuration
Command History
BGP Address-Family Status
TCP Status
OSPF Configuration
UDP Status
MPLS Forwarding Information
IP Routing Status
MPLS Trap Configuration Dialog
MPLS Interface Status
VRF Deployment
MPLS Tunnel Information
VRF Configuration
MPLS LDP Entity Status
MPLS LDP Peer Status
MPLS LDP Hello Adjacencies
VRF Status
VPN Status
Interface VRF Status
VRF Object Status
Table 21-3 Dialogs launched from Module objects
Dialog uses IOS CLI
(Need to set the Management
Passwords on the EM)
Dialog uses SNMP
WRED-Rx Configuration
Module Performance
Dialog uses IOS CLI and SNMP
(Need to set the Management
Passwords on the EM)
Module Inventory
Module Status
Cisco 12000/10700 v3.1.1 Router Manager User Guide
21-2
OL-4455-01
">
