Black Box RM403 Installing

OCTOBER 2000
525056
525057
525058
525059
525060
525061
525062
525063
525066
525067
525068
525069
525070
525071
525072
525073
525074
525075
525076
525077
525078
525079
525080
525081
525094
525095
525096
525097
525098
525099
525100
525101
536000
536001
536002
536003
39964
39965
39966
39967
39970
RM399
RM400
RM403
RM404
40169
Addendum
Elite Series Data Cabinets
This addendum contains important changes to your Elite Series Data Cabinets. Please keep this
addendum with that manual for easy reference.
The last version of your manual did not contain instructions for installing the Elite Series Sliding
Server Shelf (RM400). Included are the appropriate installation instructions.
CUSTOMER
SUPPORT
INFORMATION
Order toll-free in the U.S. 24 hours, 7 A.M. Monday to midnight Friday: 877-877-BBOX
FREE technical support, 24 hours a day, 7 days a week: Call 724-746-5500 or fax 724-746-0746
Mail order: Black Box Corporation, 1000 Park Drive, Lawrence, PA 15055-1018
Web site: www.blackbox.com • E-mail: [email protected]
ELITE SERIES DATA CABINETS
Installing the Elite Series Sliding
Server Shelf (RM400)
What’s Included
• (4) Mounting brackets
• (1) Shelf assembly
• (8) #10-32 screws
• (12) Wing nuts
Installation
1) Remove the shelf tray from the assembly by holding the cable support bar and pulling the shelf out. There
is a slide release tab on each slide. Push the tabs in and pull the shelf tray off the rest of the assembly.
2) Mount the server fins on the shelf tray. The studs on the bottom of the fins should be placed in the long
slots on the top of the shelf tray and then wing nuts are used to secure them underneath the shelf tray.
Four fins can be used if there are two servers or just two fins can be used if there is one large server.
3) Mount the remaining part of the shelf assembly to the mounting rails (at the desired height) using two 1032 screws per bracket. Do not tighten the screws.
4) Slide the shelf tray back onto the mounted portion of the assembly so that the slide locks together. Tighten
the screws on the mounting brackets once the shelf tray is secured back on the assembly.
5) Attach the cable bridges to the rear slot on the shelf tray using two wing nuts and two lock washers per
bridge.
Server fins
Cable bridge
Cable
support
bar
Shelf tray
2
">