Wattstopper PLUS
®
Sensor Interface Module
Installation Instructions • Instructions d’Installation • Instrucciones de Instalación
No: 080428 – 10/24 rev. 2
Catalog Numbers • Les Numéros de Catalogue • Los Números de Catálogo:
EN-SIM-AI/SPS-GB2-BK; EN-SIM-AI/SPS-GB2BKDR
Countries of Origin: China, Canada • Pays d’origine: Chine, Canada • Países de origen:China, Canadá
SPECIFICATIONS
Voltage..........................................22.5 VDC, supplied by GreenBus
Operating Temperature.............................40° to 131°F (40° to 55°C)
Certifications
UL 2043 Plenum Rated
UL/CUL listed under UL916. Intended for Indoor Locations.
FCC Part 15/ICES-003
Complies with Electromagnetic Compatibility (EMC) Standards:
EN 61000-4-2 EN 61000-4-4, EN 61000-4-5
DESCRIPTION
The Sensor Interface Module (SIM) provides an interface between sensors such as occupancy and photosensors to the GreenBus
communication network. The SIM is automatically addressed as soon as it is connected to the Wired Manager.
The SIM is available in two models:
• Indoor
• Damp Rated
PRODUCT SAFETY
When using electrical equipment, basic safety precautions should always be followed, including the following:
• Do not mount near gas or electric heaters or let power supply cords touch hot surfaces.
• Equipment should be mounted in locations and at heights where it will not readily be subjected to tampering by unauthorized personnel.
• The use of accessory equipment is not recommended by Legrand as it may cause an unsafe condition.
• Do not use this equipment for other than the intended use.
WIRED SYSTEM OVERVIEW
GreenBus technology makes wiring fast and error-free, since it’s intuitive to install.
Third-Party
Sensor
SIM
Controller
Third-Party
Sensor
SIM
Controller
Wired Manager — GreenBus
User Interface
User Interface
Wire Key
Ethernet
GreenBus
Dimming
SIM Wiring
SSU
INSTALLATION AND MOUNTING
The SIM (EN-SIM-AI/SPS-GB2-BK) is to be installed in dry, indoor locations ONLY. For damp installations, use the Damp Rated SIM
(EN-SIM-AI/SPS-GB2BKDR). Damp locations are defined as: interior locations subject to moderate degrees of moisture, such as some
basements, some barns, some cold-storage warehouses, and partially protected locations under canopies, marquees, roofed open
porches, and the like.
Legrand recommends securely mounting the LCM to the junction box using a PG-7 (0.5 inch) trade-size knockout and retainer nut.
When mounting, secure the retainer nut before wiring the module.
The module is made from tested material to be used in plenum or “plenum rated” areas.
Electrical
Junction Box
Ceiling
Tile
Low-Voltage
Occupancy Sensor
or Photosensor
WIRING
Low-Voltage
Wattstopper or
Third Party Sensor
RED
BLACK
BLUE (Signal)
Photo Sensor
Power +
Power +
RED
BLACK (Common)
Common -
BLUE
Control
Signal
RED
BLACK
Normally Open (N.O.)
Dry Contact
BLUE
Black wire not used.
Cap off wire end with UL Listed wire nut.
2
Return -
GreenBus Wiring
The GreenBus wiring originates at the Wired Manager and propagates in a daisy-chain from module to module (or other compatible
equipment).
If changes are required, determine an optimum wiring path utilizing the supplied prefabricated cables, based on the position of
luminaires and sensors. Because the modules obtain power via the GreenBus devices, the number of modules on each chain is limited.
Legrand suggests leaving room for future system upgrades and to limit the number of modules per chain to 80 units during initial
installation (validated using a voltage drop calculator). The GreenBus wires must be used with proprietary connectors supplied. Insert
the connectors into the SIM GreenBus ports.
NOTE: GreenBus must be laid out as per supplied system layout drawing. If changes are required, determine an optimum wiring path
utilizing the supplied cables, based on the position of the devices.
7 mm
(0.27 inch)
Insert
Connectors
Insert
Wires
To remove the wires, use a flat head screwdriver to release the wires from the terminal blocks.
Insert flat head
screwdriver
into release tab
3
WARRANTY INFORMATION
INFORMATIONS RELATIVES À LA GARANTIE
INFORMACIÓN DE LA GARANTÍA
Wattstopper warranties its products to be free
of defects in materials and workmanship for a
period of five (5) years. There are no obligations
or liabilities on the part of Wattstopper for
consequential damages arising out of, or in
connection with, the use or performance of this
product or other indirect damages with respect
to loss of property, revenue or profit, or cost of
removal, installation or reinstallation.
Wattstopper garantit que ses produits sont
exempts de défauts de matériaux et de fabrication
pour une période de cinq (5) ans. Wattstopper
ne peut être tenu responsable de tout dommage
consécutif causé par ou lié à l’utilisation ou
à la performance de ce produit ou tout autre
dommage indirect lié à la perte de propriété, de
revenus, ou de profits, ou aux coûts d’enlèvement,
d’installation ou de réinstallation.
Wattstopper garantiza que sus productos
están libres de defectos en materiales y mano
de obra por un período de cinco (5) años. No
existen obligaciones ni responsabilidades por
parte de Wattstopper por daños consecuentes
que se deriven o estén relacionados con el
uso o el rendimiento de este producto u otros
daños indirectos con respecto a la pérdida
de propiedad, renta o ganancias, o al costo
de extracción, instalación o reinstalación.
No. 080428 – 10/24 rev. 2
© Copyright 2024 Legrand All Rights Reserved.
© Copyright 2024 Tous droits réservés Legrand.
© Copyright 2024 Legrand Todos los derechos reservados.
800.879.8585
www.legrand.us/wattstopper
">
