Whadda WMS101 MICROBIT ACCELERATION MEASUREMENT KIT Quick Start Guide

QuickStart guide WMS101
The WMS101is a Micro Bit Acceleration Measurement Kit with 0.96-inch OLED screen and Motor
shield. You can view acceleration data on the bright OLED screen and control motors.
The Arduino is already preprogrammed with our
code, but you can modify and download the
Arduino source code on our GitHub page using
the QR code below.
For a more detailed version of the assembly
instructions and explanation how it works, you
can follow our tutorial video using the QR code
below.
Now unbox everything and connect the OLED screen to the motor board like in the picture below using
4X Female to Female jumper cables
Make sure the Slide switch is set to 3V3
Now connect the battery using the 9V battery clip and connect the wires to the terminal on the
Motor Shield, Dont switch the wires!
Connect the Micro Bit and set the ON/OFF switch of the motor board to ON.
Press the RESET button on the back of the Micro Bit, and the OLED screen should light up. Now
follow the instructions on the screen.
Below you can find an example on how to use the
Acceleration Kit. Mount it on any device that moves,
crash your car, and see how many force it endured.
">