HomeDVR-KT1 Quick Start Guide
One Outdoor Wireless Camera System Kit Audio,
Night Vision, and SD DVR
Package Contents
* HomeDVR
* Remote Control
* Camera (SM-302TX)
* Receiver (SM-302RX)
* Cables
* Accessories
Installation
I Connect the power adapter (DC 8V, 300mA) to the
wireless camera and the other end into an electrical outlet
as shown on the right.
li Check to make sure the antenna is connected to the
wireless receiver as shown on the right.
lil Connect the power adapter (DC 8V, 300mA) to the
receiver and the other end into an electrical outlet. Press
the ch Power ON/OFF button to turn on the wireless
receiver as illustrated on the right.
IV The receiver should be default matches and use 906MHz
frequency or CHI. Please be noted that the CH button is
not applicable in this model as shown on the right.
V Locate the AV cable provided; connect one end of the AV
cable 3.5mm jack to the HomeDVR AV IN 1 port and
connect the other end into the red (white to red) audio
socket and yellow (yellow to yellow) video socket of the
wireless receiver as illustrated on the right.
Power ON/OFF Button
Channel Select Button “CH"
AN Out to HomeDVR“AV IN 1” |
HomeDVR-KT1 Quick Start Guide
One Outdoor Wireless Camera System Kit Audio,
Night Vision, and SD DVR
Vi Locate the AV cable provided; connect one end of the
AV cable 3.5mm jack to the HomeDVR AV OUT port om ne
and then connect the other end to the AV input of a ==" Noto TVDVNOR | o co oo
monitor Cie. CCTV monitor, TV, and etc.). Be sure to match
the color of the AV input socket when connecting to a
monitor source. Turn on the monitor and change the monitor
video (ie. LINET, LINE2, VIDEO1, VIDEO2, and etc.) to the
auxiliary input mode.
vil Connect the power adapter (DC 6V, 800mA) to the
HomeDVR power socket and the other end into an electrical
outlet.
Viii Insert an SD card (not included) into HomeDVR’s SD card
slot. Make sure the SD card clicks into the card slot when
Inserting.
IX Turn on the HomeDVR using the db power ON/OFF switch
located at the right-side front of the DVR. Verify the power
LED light is lit and a HomeDVR start up screen will display in
blue as shown on the right.
X Press the “REC” button to start manual recording.
NOTE: Please note the SD memory card is NOT included in the package. HomeDVR use a
standard SD memory card memory, supporting up to 32GB in capacity. For alarm input, alarm
output, motion detection, and all other inquiry, please reference the HomeDVR-KT1 user's
manual for detail.
">
