POWERED SPEAKER SYSTEM
ZN19540
DBR series
Technical Specifications
General Specifications
General
DBR15
System Type
2-way, Bi-amp Powered Speaker, Bass-reflex Type
Frequency Range (-10dB)
50 Hz–20 kHz
Coverage Angle
H90° x V60° Constant Directivity Horn
Crossover Type
FIR-X Tuning (Linear Phase FIR Filter)
Crossover Frequency
Measured Maximum SPL (Peak) IEC noise@1m
Transducer
LF
HF
DBR12
DBR10
52 Hz–20 kHz
55 Hz–20 kHz
2.1 kHz
2.1 kHz
2.1 kHz
132 dB SPL
131 dB SPL
129 dB SPL
DBR15
DBR12
DBR10
Diameter
15" Cone
12" Cone
10" Cone
Voice coil
2.5"
2"
2"
Magnet
Ferrite
Diaphragm
1.4"
Type
1" Throat Compression Driver
Magnet
Ferrite
1"
Enclosure
DBR15
Material, Color
Plastic, Black
DBR12
DBR10
Floor Monitor Angle
50° Symmetrical
50° Symmetrical
50°
Dimensions (WxHxD, with rubber feet)
455 x 700 x 378 mm (17.9" x 27.6" x 14.9")
376 x 601 x 348 mm (14.8" x 23.7" x 13.7")
308 x 493 x 289 mm (12.1" x 19.4" x 11.4")
Net Weight
19.3 kg (42.6 lbs)
15.8 kg (34.8 lbs)
10.5 kg (23.2 lbs)
Handles
Side x 2
Pole Socket
35mm
Rigging Points
Bottom x 2, Rear x 1 (Fit for M8 x 15mm Eyebolts)
Optional Seaker Bracket
BBS251, BCS251, BWS251-300, BWS251-400
Amplifier
DBR15
Amplifier Type
Top x 1
Bottom x 2 (Fit for M8 x 15mm Eyebolts)
DBR12
DBR10
Class-D
Power Rating *1
Dynamic
1000 W (LF: 800 W, HF: 200 W)
700 W (LF: 500 W, HF: 200 W)
Continuous
465 W (LF: 400 W, HF: 65 W)
325 W (LF: 260 W, HF: 65 W)
Cooling
Fan Cooling, 4 Speeds.
AD/DA
24bit 48kHz Sampling
HPF/LPF
OFF, 100Hz, 120Hz, 24dB/Oct. HPF
DSP Preset
D-CONTOUR: FOH/MAIN, MONITOR, OFF
Protection
Connectors
Speaker
Clip Limiting, Integral Power Protection, DC-fault
Amplifier
Thermal, Output Over Current
Power Supply
Thermal, Output Over Voltage, Output Over Current
Input
Input1: Combo x1, Input2: Combo x1, RCA PIN x2 (Unbalanced)
Output
Output: XLR3-32 x1 (CH1 Parallel Through or CH1+CH2 Mix)
Input Impedance
INPUT1 (XLR, Phone): 3 kΩ, INPUT2 (XLR, Phone, RCA Pin): 10 kΩ
Input Sensitivity (LEVEL: Maximum)
INPUT1: LINE: 0 dBu, MIC: -32 dBu, INPUT2: 0 dBu
Input Sensitivity (LEVEL: Center)
INPUT1: LINE: +10 dBu, MIC: -22 dBu, INPUT2: +10 dBu
Maximum Input Level
INPUT1: LINE: +24 dBu, MIC: -8 dBu, INPUT2: +24 dBu
Controls
LEVEL x2, LINE/MIC, HPF, D-CONTOUR, THRU/MIX, POWER
Idle Power Consumption
18 W
18 W
1/8 Power Consumption
74 W
60 W
Power Requirements
100 V, 100–120V, 220–240 V, 110/127/220 V (Brazil), 50/60 Hz
0 dBu is referenced to 0.775Vrms.
*1 Power Rating (120V, 25°C). This is total value of individual output power.
Specifications and descriptions in this owner’s manual are for information purposes only. Yamaha Corp. reserves the right to change or modify products or specifications at any time without prior notice. Since
specifications, equipment or options may not be the same in every locale, please check with your Yamaha dealer.
Block Diagram
INPUT
Combo
(Balance)
DSP
LEVEL
SIGNAL
HA
1 (MIC/LINE)
MIC/LINE
Combo
(Balance)
AD
LEVEL
HPF
HF
D-CONTOUR
120Hz
FOH/MAIN
100Hz
OFF
OFF
MONITOR
HF
EQ
EQ
FIR-X
LF
EQ
Delay
Limiter
Mute
DA
●LIMIT
●PROTECTION
Limiter
Mute
2 (LINE)
(CH1+2 MIX)
OUTPUT
Pin
(CH1 THRU)
Temp.
DC-fault
Output
Current
Output
Voltage
Integral
Output
Power
On/Off
Mute
Protection Logic
LF
DA
HA
Amp.
(HF)
Amp.
(LF)
Dimensions
M8 depth 17mm
700
126
DBR15
455
2-M8 depth 17mm
378
50°
464
163
173
150
For pole φ35mm
Unit: mm
M8 depth 17mm
601
102
DBR12
376
50°
408
152
2-M8 depth 17mm
348
162
150
For pole φ35mm
Unit: mm
493
DBR10
308
336
289
138
2-M8 depth 17mm
For pole φ35mm
50°
148
120
Unit: mm
C.S.G., PA Development Division
© 2014 Yamaha Corporation
Published 07/2014 发行 KSZC*.*-01A0
Printed in Indonesia
">
