SoundStructure VoIP Interface Quick Upgrade Guide
Follow these steps to upgrade your existing SoundStructure System from a TEL1 or TEL2 based design to a
SoundStructure VoIP Interface. Refer to the latest SoundStructure Design Guide for additional design information.
1 Install SoundStructure Studio v1.7.0 or later
2 Run SoundStructure Studio, connect to your SoundStructure system, and
‘Get’ the configuration from the devices
Copyright 2011 Polycom Inc. All rights reserved. Version 1.0 | 1725-33217-001 / A
3 If you have a functional SoundStructure system, save your online project to your computer
4 If system is already running firmware v1.5.0, select disconnect to take the system offline and go to Step 6.
5 Update your SoundStructure system to SoundStructure firmware v1.5.0 or later.
( Only appears if changes have
been made to the project )
5 Update your SoundStructure system to SoundStructure firmware v1.5.0 or later (continued)
Online System
Offline System
6 Run the Upgrade Plug-in Card Tool to upgrade your SoundStructure Studio project with a
SoundStructure VoIP Interface plug-in card. If you already have a SoundStructure VoIP
Interface-based configuration file, go to Step 7.
6 Run the Upgrade Plug-in Card Tool (continued)
7 Disconnect power
Upgraded project
8 Replace the plug-in card(s)
LAN C-LINK2
PHONE LINE
IN OBAM OUT IR 12V
PIN 2: TXD
PIN 3: RXD
PIN 5: GROUND
PIN 7: CTS
PIN 8: RTS
RS-232 REMOTE CONTROL 1
REMOTE CONTROL 2
0004F2009EFF
PHONE LINE
LAN C-LINK2 IN OBAM OUT IR 12V
PIN 2: TXD
PIN 3: RXD
PIN 5: GROUND
PIN 7: CTS
PIN 8: RTS
RS-232 REMOTE CONTROL 1
REMOTE CONTROL 2
9 Connect the VoIP LAN to the network
0004F2BF001D
IN OBAM OUT IR 12V LAN C-LINK2
10 Reconnect power and wait for the system to power up
11 Send the updated configuration file created in step 6 to the SoundStructure system
Offline
System
Online
System
SoundStructure VoIP Interface Quick VoIP Setup
Follow these steps to configure your SoundStructure VoIP Interface. Refer to the latest SoundStructure Design
Guide for additional SoundStructure design information and examples.
12 Confirm VoIP network settings or manually configure to match your environment
13 Launch Web Configuration Utility
Default Admin Password: 456
14 Use Simple Setup to configure the SIP settings
Select time server and time zone
Enter SIP server address
Enter SIP proxy server
Enter SIP Line settings
15 Confirm Line Registration
Unregistered Line
Go to step 14
Line Not Registered?
Line
Registered?
Finished!
Registered Line
