HS403A, HS404A 6/27/00 1:01 PM Page 901

Eloquent Headsets with 2.5-mm Connector

Convertible, HS403A

Compact, HS404A

HS403A, HS404A 6/27/00 1:01 PM Page 1

FCC INFORMATION

FEDERAL COMMUNICATIONS COMMISSION

AND

INDUSTRY CANADA

RADIO FREQUENCY INTERFERENCE STATEMENTS

This equipment generates, uses, and can radiate radio frequency energy and if not installed and used properly, that is, in strict accordance with the manufacturer’s instructions, may cause interference to radio communication. It has been tested and found to comply with the limits for a Class A computing device in accordance with the specifications in Subpart J of Part 15 of FCC rules, which are designed to provide reasonable protection against such interference when the equipment is operated in a commercial environment. Operation of this equipment in a residential area is likely to cause interference, in which case the user at his own expense will be required to take whatever measures may be necessary to correct the interference.

Changes or modifications not expressly approved by the party responsible for compliance could void the user’s authority to operate the equipment.

This digital apparatus does not exceed the Class A limits for radio noise emission from digital apparatus set out in the Radio Interference Regulation of Industry Canada.

Le présent appareil numérique n’émet pas de bruits radioélectriques dépassant les limites applicables aux appareils numériques de classe A prescrites dans le Règlement sur le brouillage radioélectrique publié par Industrie Canada.

1

HS403A, HS404A 6/27/00 1:01 PM Page 2

ELOQUENT HEADSETS WITH 2.5 MM CONNECTOR

FCC REQUIREMENTS FOR

TELEPHONE-LINE EQUIPMENT

1. The Federal Communications Commission (FCC) has established rules which permit this device to be directly connected to the telephone network with standardized jacks. This equipment should not be used on party lines or coin lines.

2. If this device is malfunctioning, it may also be causing harm to the telephone network; this device should be disconnected until the source of the problem can be determined and until the repair has been made. If this is not done, the telephone company may temporarily disconnect service.

3. If you have problems with your telephone equipment after installing this device, disconnect this device from the line to see if it is causing the problem If it is, contact your supplier or an authorized agent.

2

4. The telephone company may make changes in its technical operations and procedures. If any such changes affect the compatibility or use of this device, the telephone company is required to give adequate notice of the changes.

HS403A, HS404A 6/27/00 1:01 PM Page 3

FCC INFORMATION

5. If the telephone company requests information on what equipment is connected to their lines, inform them of: a. The telephone number that this unit is connected to.

b. The ringer equivalence number.

c. The USOC jack required: RJ-11C.

d. The FCC registration number.

Items (b) and (d) can be found on the unit’s FCC label. The ringer equivalence number (REN) is used to determine how many devices can be connected to your telephone line. In most areas, the sum of the RENs of all devices on any one line should not exceed five (5.0). If too many devices are attached, they may not ring properly.

6. In the event of an equipment malfunction, all repairs should be performed by your supplier or an authorized agent. It is the responsibility of users requiring service to report the need for service to the supplier or to an authorized agent.

3

HS403A, HS404A 6/27/00 1:01 PM Page 4

CERTIFICATION NOTICE FOR

EQUIPMENT USED IN CANADA

The Canadian Department of Communications label identifies certified equipment. This certification means that the equipment meets certain telecommunicationsnetwork protective, operation, and safety requirements.

The Department does not guarantee the equipment will operate to the user’s satisfaction.

Before installing this equipment, users should ensure that it is permissible to be connected to the facilities of the local telecommunications company. The equipment must also be installed using an acceptable method of connection. In some cases, the company’s inside wiring associated with a single-line individual service may be extended by means of a certified connector assembly

(extension cord). The customer should be aware that compliance with the above conditions may not prevent degradation of service in some situations.

Repairs to certified equipment should be made by an authorized Canadian maintenance facility—in this case, your supplier. Any repairs or alterations made by the user to this equipment, or equipment malfunctions, may

4

HS403A, HS404A 6/27/00 1:01 PM Page 5

CDC NOTICE

give the telecommunications company cause to request the user to disconnect the equipment.

Users should ensure for their own protection that the electrical ground connections of the power utility, telephone lines, and internal metallic water pipe system, if present, are connected together. This precaution may be particularly important in rural areas.

5

HS403A, HS404A 6/27/00 1:01 PM Page 6

6

NORMAS OFICIALES MEXICANAS (NOM)

ELECTRICAL SAFETY STATEMENT

INSTRUCCIONES DE SEGURIDAD

1. Todas las instrucciones de seguridad y operación deberán ser leídas antes de que el aparato eléctrico sea operado.

2. Las instrucciones de seguridad y operación deberán ser guardadas para referencia futura.

3. Todas las advertencias en el aparato eléctrico y en sus instrucciones de operación deben ser respetadas.

4. Todas las instrucciones de operación y uso deben ser seguidas.

5. El aparato eléctrico no deberá ser usado cerca del agua—por ejemplo, cerca de la tina de baño, lavabo, sótano mojado o cerca de una alberca, etc..

6. El aparato eléctrico debe ser usado únicamente con carritos o pedestales que sean recomendados por el fabricante.

7. El aparato eléctrico debe ser montado a la pared o al techo sólo como sea recomendado por el fabricante.

8. Servicio—El usuario no debe intentar dar servicio al equipo eléctrico más allá a lo descrito en las instrucciones de operación. Todo otro servicio deberá ser referido a personal de servicio calificado.

9. El aparato eléctrico debe ser situado de tal manera que su posición no interfiera su uso. La colocación del aparato eléctrico sobre una cama, sofá, alfombra o superficie similar puede bloquea la ventilación, no se debe colocar en libreros o gabinetes que impidan el flujo de aire por los orificios de ventilación.

HS403A, HS404A 6/27/00 1:01 PM Page 7

NOM STATEMENT

10. El equipo eléctrico deber ser situado fuera del alcance de fuentes de calor como radiadores, registros de calor, estufas u otros aparatos (incluyendo amplificadores) que producen calor.

11. El aparato eléctrico deberá ser connectado a una fuente de poder sólo del tipo descrito en el instructivo de operación, o como se indique en el aparato.

12. Precaución debe ser tomada de tal manera que la tierra fisica y la polarización del equipo no sea eliminada.

13. Los cables de la fuente de poder deben ser guiados de tal manera que no sean pisados ni pellizcados por objetos colocados sobre o contra ellos, poniendo particular atención a los contactos y receptáculos donde salen del aparato.

14. El equipo eléctrico debe ser limpiado únicamente de acuerdo a las recomendaciones del fabricante.

15. En caso de existir, una antena externa deberá ser localizada lejos de las lineas de energia.

16. El cable de corriente deberá ser desconectado del cuando el equipo no sea usado por un largo periodo de tiempo.

17. Cuidado debe ser tomado de tal manera que objectos liquidos no sean derramados sobre la cubierta u orificios de ventilación.

18. Servicio por personal calificado deberá ser provisto cuando:

A: El cable de poder o el contacto ha sido dañado; u

B: Objectos han caído o líquido ha sido derramado dentro del aparato; o

C: El aparato ha sido expuesto a la lluvia; o

D: El aparato parece no operar normalmente o muestra un cambio en su desempeño; o

E: El aparato ha sido tirado o su cubierta ha sido dañada.

7

HS403A, HS404A 6/27/00 1:01 PM Page 8

Incidental or Consequential Damages

Neither the headset manufacturer nor Black Box

Corporation has any responsibility for any incident or consequential damages including, without limitation, commercial loss, or for any incidental expenses, loss of time, or inconvenience. Some states do not allow the exclusion or limitation of incidental or consequential damages, so the above limitation or exclusion may not apply to you.

TRADEMARKS USED IN THIS MANUAL

Any trademarks mentioned in this manual are acknowledged to be the property of the trademark owners.

8

HS403A, HS404A 6/27/00 1:01 PM Page 9

CHAPTER 1: Specifications

1. Specifications

Transmit

Frequency Range:

100 to 6000 Hz

Microphone:

Noise-canceling electret

Power:

Current consumption: <300 µa; Operating voltage: 1.5 to 10 VDC

Receive

Frequency Response:

250 to 4000 Hz

Speaker:

150 ohms

General

Connectors:

2.5 mm

Cord Length:

4 ft. (1.2 m)

Weight: Convertible: 0.75 oz. (21.3 g); Compact: 0.5 oz.

(14.2 g)

9

HS403A, HS404A 6/27/00 1:01 PM Page 10

2. Introduction

Now you can have hands-free comfort while using your cell phone. Not only do these headsets give you the freedom to keep both your hands on the wheel, but they also offer outstanding sound quality and comfort.

The noise-canceling microphone helps to screen out road and other noises so your caller can hear you better.

And the headphone positions the speaker against your ear perfectly so you can hear your caller more clearly.

10

HS403A, HS404A 6/27/00 1:01 PM Page 11

CHAPTER 3: Installation and Operation

3. Installation and Operation

CAUTION

When using the Eloquent Headset in the car, avoid leaving the headset in direct sunlight for prolonged periods of time.

This could cause irreparable damage.

3.1 The Compact Eloquent Headset with 2.5 mm Connector

(HS404A)

11

HS403A, HS404A 6/27/00 1:01 PM Page 12

3.2 The Convertible Eloquent Headset with 2.5 mm Connector

(HS403A)

3.2.1 O

VER

-

THE

-H

EAD

O

PTION

12

Over the Head (Left Ear).

HS403A, HS404A 6/27/00 1:01 PM Page 13

CHAPTER 3: Installation and Operation

Over the Head (Right Ear).

1/2"

(12 mm)

Over the Head.

13

HS403A, HS404A 6/27/00 1:01 PM Page 14

3.2.2 O

N

-

THE

-E

AR

O

PTION

For use on right ear

For use on left ear

1/2 "

(12 mm)

14

HS403A, HS404A 6/27/00 1:01 PM Page 15

CHAPTER 3: Installation and Operation

3.3 Connecting the Headset to Your Cell Phone

The connector on this headset is a 2.5-mm plug. If your cellular phone does not have a 2.5-mm receptacle, optional cellular adapters are available from Black Box.

Insert the headset plug into the headset port or adapter

(if required) on your telephone.

2.5 mm port

1

GHI

4

ABC

2

JKL

5

DEF 3

MNO

6

PQRS

7

*

TUV

8

OPER

0

WXYZ

9

#

Connecting to the Mobile Telephone via the 2.5-mm Connector.

15

HS403A, HS404A 6/27/00 1:01 PM Page 16

ELOQUENT HEADSETS WITH 2.5 MM CONNECTOR

Adapter not included

*

7

1

4

0

2

8

5

#

9

6

3

2.5 mm port

Connecting to the Cellular Phone with an Optional Adapter (ordered separately).

Call Black Box Technical Support at 724-746-5500 for details.

16

HS403A, HS404A 6/27/00 1:01 PM Page 17

CHAPTER 4: Troubleshooting

4. Troubleshooting

4.1 Calling Black Box

If you determine that your Eloquent Headset is malfunctioning, do not attempt to alter or repair the unit. It contains no user-serviceable parts. Contact Black

Box at 724-746-5500.

Before you do, make a record of the history of the problem. We will be able to provide more efficient and accurate assistance if you have a complete description, including:

• the nature and duration of the problem.

• when the problem occurs.

• the components involved in the problem.

• any particular application that, when used, appears to create the problem or make it worse.

17

HS403A, HS404A 6/27/00 1:01 PM Page 18

ELOQUENT HEADSETS WITH 2.5 MM CONNECTOR

4.2 Shipping and Packaging

If you need to transport or ship your Eloquent Headset:

• Package it carefully. We recommend that you use the original container.

• If you are shipping the Eloquent Headset for repair, make sure you include everything that came in the original package. Before you ship, contact Black Box to get a Return Materials

Authorization (RMA) number.

18

HS403A, HS404A 6/27/00 1:01 PM Page 900

CUSTOMER SUPPORT INFORMATION

Order toll-free in the U.S.: Call 877-877-BBOX (outside U.S. call 724-746-5500)

FREE technical support 24 hours a day, 7 days a week: Call 724-746-5500 or fax 724-746-0746

Mailing address: Black Box Corporation, 1000 Park Drive, Lawrence, PA 15055-1018

Web site: www.blackbox.com • E-mail: [email protected]

© Copyright 2000. Black Box Corporation. All rights reserved.

54-0188A

June 2000

Printed in USA