REF
Child Size R8592313
Adult Size R8592318
3
Intended use
This product is intended for showering/changing a person who is unable to
stand up or sit down. The person is lying horizontally on the shower table.
Intended operator profile
The product is to be used by a person trained in health care and/or trained in
washing/changing a person in their care.
Intended user profile
The product can be used by all - adults, children, young, old, whose weight
does not exceed the maximum load of 200 kg / 440 lbs.
Operating environment
For indoor use in a wet environment, such as a bathroom or wash room.
The product is intended to be used at room temperature, in private homes,
nursing homes and hospitals under normal working conditions.
Contraindications for use
Use of the unit is not recommended for patients with infusion or insulin
pump, inflammatory skin diseases or patients in feverish conditions.
en Patients with cardiac insufficiency, cardiovascular diseases, craniocerebral
injury, open wounds, feed or drain lines (e.g. catheter, drainage tube) may use
the unit only after consulting with the attending physician.
Biocompatibility
The materials in contact with the skin of the user during the intended use
have been evaluated for their content of harmful substances according to
the procedures in BS EN ISO 10993-1:2020 Biological evaluation of medical
devices – Part 1 and are therefore considered suitable for this purpose.
!
CAUTION
The surface of the product may become hot and / or cold if exposed to
external sources of heat or cold (eg sunlight or frost).
12
The product is to be cleaned with hot water or a mild soapy cleaning agent.
A list of suitable cleaning agents tested by Pressalit can be found on
www.pressalit.com.
!
CAUTION
Always read the material safety data sheet (MSDS) and supplied
instructions of the cleaning, disinfecting or de-scaling agent and comply
with instructions for safe use, dilution, rinsing, drying, handling and
storage of the agent.
IMPORTANT
• Do not use an autoclave or other type of steam cleaner.
• Avoid aggressive cleaning agents containing acids.
• Never spray the product directly with a high pressure cleaner.
en
• Avoid use of abrasive, corrosive or chlorine-based cleaning or
disinfecting products.
Disinfection
When using the shower table for multiple patients, it is necessary to both
clean and disinfect the shower table between uses on different patients to
prevent the risk of cross infection.
NOTICE
If the product is installed in an atmosphere heavy in salt or chloride, the
warranty of the shower table will be reduced from the normal 3 years to
1 year.
Salt and chloride have a corrosive effect on the products components and
will cause a decrease in the life expectancy of the product. The damaging
effects can, however, be reduced if the product is showered with tap water
on a daily basis.
18
Electromagnetic immunity
Electrostatic discharge
The product must not be affected by electrical discharge
between a person and the product in such a way as to
initiate actions or render components defective.
Test
standard
Immunity test level
EN 61000-4-2
+/- 8 kV contact
+/- 2, 4, 8, 15 kV air
Radiated RF electromagnetic field
The product must not be affected by radiating RF signals,
for example from a mobile phone or radio, that could
cause the product to take action or to make components
defective.
Test
standard
Immunity test level
EN 61000-4-3
15 V/m 80 MHz to 1000 MHz (only on the front)
15 V/m 1,01 GHz to 3 GHz
80 % AM 1 kHz
en
25
Disposal and recycling
The unit contains reusable materials. There are no known hazards or risks
associated with disposal of the product. All components can be discarded
after having been cleaned and disinfected.
When disposing of the product, we recommend that it be disassembled and
broken down into different waste groups for recycling or combustion.
The following table provides information on the recycling and handling of the
product.
Recyclable
components
Aluminium
Steel
Material
Aluminium is theoretically 100% recyclable without
any loss of its natural qualities. It requires only 5% of
the energy used to produce primary aluminium. The
quality of recycled aluminium is so high that it can
be used again and again, even in the case of anodised
products as the anodised layer is a natural part of the
aluminium.
Steel can be recycled by being re-melted and included
as a secondary material in the production of new
steel.
PVC and
polystyrene
Hard PVC is granulated and re-melted.
Use plastic sorting and recycling systems where they
are locally available, otherwise incinerating plastic
has the added benefit of generating energy, which can
be used for, for example, combined heat and power
production.
Polyurethane
Like other plastics, polyurethane can be recycled in
two primary ways: mechanical recycling, in which the
material is reused in its polymer form, and chemical
recycling that takes the material back to its various
chemical constituents.
Electronics
The electronic components should be collected
separately and returned to the designated recycling
service.
en
29
">
