Wall Panel
Installation Guide
BSS Audio
8760 S. Sandy Parkway
Sandy, Utah 84070, USA http://www.bssaudio.com
801-566-8800
1
DECLARATION OF CONFORMITY
Manufacturer’s Name: BSS Audio
Manufacturer’s Address: declares that the product:
8760 S. Sandy Parkway
Sandy, Utah 84070, USA
Note: Product name may be suffixed by the letters-EU. conforms to the following Product Specifications:
EMC: EN 55103-1 (1996)
EN 55103-2 (1996)
Supplementary Information:
The product herewith complies with the requirements of the Low Voltage Directive 73/23/EEC and the
EMC Directive 89/336/EEC as amended by Directive 93/68/EEC.
European Contact:
Vice-President of Engineering – Pro
8760 S. Sandy Parkway
Date: October 24, 2005
Your local BSS Audio Sales and Service Office or
Harman Music Group
8760 South Sandy Parkway
Sandy, Utah 84070, USA
Ph: (801) 566-8800
Fax: (801) 566-7005
Introduction
We have written this guide with the aim of helping installers and sound engineers alike to get the most out of the BLU-10. We recommend that you read this manual, before attempting to operate the unit. We welcome any comments or questions regarding the BLU-10 or other BSS products, and you may contact us at the address or world wide web sites given overleaf.
Regulatory Information
An example of this equipment has been tested and found to comply with the following
European and International Standards for Electromagnetic Compatability (only when used with a metal wall-box):
FCC part 15 Class A
EN55103-1: 1996 (E2)
EN55103-2: 1996 (E2)
2
Mechanical Installation
The BLU-10 is designed to fit into a standard 3-gang US wall box. Screws are provided to fix the unit in place.
Dimensions of the unit are shown below. The use of a metal wall box is recommended to ensure that the installation meets necessary EMC standards.
57mm
2.24ins
170mm
6.69ins
45mm
1.77ins
Power
The BLU-10 requires 12-48V DC to be supplied externally. There are two ways to do this:
Connect a suitable supply to the 12-48V DC connector, see diagram below, or the unit may be power via the Ethernet connector using IEEE802.3af Power Over
Ethernet (POE).
Typical mid-span ethernet powering devices are:
3Com® Power over Ethernet Single-Port Midspan Solution - p/n 3CNJPSE
3Com® Power over Ethernet Multiport Midspan Solution - p/n 3CNJPSE24
Ethernet switches with power over ethernet ports include:
3Com® SuperStack® 3 Switch 4400 PWR - p/n 3C17205
HP ProCurve Switch 2626-PWR - p/n J8164A#ABA
3
12-48V DC
Power
Connector
USB
Connector
Ethernet
Connector
Wiring
The BLU-10 connects into a Soundweb London network via its Ethernet port, either directly into the rear of a rackmount device (e.g., BLU-16) with a Cat 5 crossover cable, or with a standard Cat 5 cable into an Ethernet switch.
Technical Specifications
Maximum network cable length:
Power consumption:
300 feet (100 meters)
300mA max at 12V
4
18-1234-B
