Frigidaire Professional FPMO3077TF, FPMO3077TF , EMBD3010AS, PMBD3080AF Installation instructions

BUILT-IN CONVECTION MICROWAVE INSTALLATION INSTRUCTIONS
United States
and Canada
INSTALLATION AND SERVICE MUST BE PERFORMED BY A QUALIFIED INSTALLER.
IMPORTANT: SAVE FOR LOCAL ELECTRICAL INSPECTOR'S USE.
READ AND SAVE THESE INSTRUCTIONS FOR FUTURE REFERENCE.
FOR YOUR SAFETY: Do not store or use gasoline or other flammable vapors
and liquids in the vicinity of this or any other appliance.
Your new microwave oven has been designed to fit a limited variety of cutout sizes to make
the job of installing easier. The first step of your installation should be to measure your current
cutout dimensions and compare them to the cutout dimensions chart below for your model.
You may find little or no cabinet work being necessary.
Important Notes to the Installer
1. Read all of the installation instructions before installing the microwave oven.
2. Remove all packing material from the oven compartments before connecting the electrical supply to the
microwave oven.
3. Observe all governing codes and ordinances.
4. Be sure to leave these instructions with the consumer.
5. The oven door may be removed to facilitate installation.
Important Notes to the Consumer
Keep these instructions with your Owner's Guide for the
local electrical inspector's use and future reference.
IMPORTANT SAFETY INSTRUCTIONS
•
•
Be sure your microwave oven is installed and
grounded properly by a qualified installer or service
technician.
This microwave oven must be electrically grounded
in accordance with local codes or, in their absence,
with the National Electrical Code ANSI/NFPA No.
70- latest edtion in the United States, or with CSA
Standard C22.1, Canadian Electrical Code, Part 1, in
Canada.
Stepping, leaning, or sitting on the door
of this microwave oven can result in serious injuries and
can also cause damage to the microwave oven.
•
Never use your microwave oven for warming or heating the room. Prolonged use of the microwave oven
without adequate ventilation can be dangerous.
1.
Carpentry
2.
Electrical Requirements
Refer to figure 2, 3, or 4 for the dimensions applicable to
your appliance and the space necessary to receive the
oven. The oven support surface may be solid plywood or
similar material, however, the surface must be level from
side to side and from front to rear.
This appliance must be supplied with the proper voltage
and frequency, and it must be connected to an individual,
properly grounded branch circuit protected by a circuitbreaker or fuse.
Electrical Requirements:
• A three-prong grounded outlet
• 120 V, 60 Hz, AC only
• 20 Amp electrical supply with a fuse or a circuit
breaker
• 20 Amp outlet duplex must be used
Figure 1: 3-prong 20-Amp Grounded Outlet
The electrical power to the microwave
oven must be shut off while line connections are being
made. Failure to do so could result in serious injury or
death.
PN A06822905 Rev. A (17/08)
Printed in U.S.A.
1
English – pages 1-5
Español – páginas 6-10
Français – pages 11-15
BUILT-IN CONVECTION MICROWAVE INSTALLATION INSTRUCTIONS
3.
Cabinet Installation
1. Unpack the microwave oven.
2. Find the two mounting screws included in the literature package.
3. Insert the oven into the cabinet opening.
4. Push the oven in and against the cabinet.
Do not lift or manipulate the oven door handle
or the control panel.
Heavy Weight Hazard
•
Use two or more people to move and install the
microwave oven.
Failure to follow this instruction can result in injury
or damage to the unit.
•
NOTES:
1. The base must be capable of supporting 155 pounds
(70 kg).
2. Allow at least 21" (53.3 cm) clearance in front of the
oven for door depth when it is open.
3. Dimension G (cutout depth) is critical to the proper
installation of the built-in oven. If the oven decorative
trim does not lie flush against the cabinet, or if noise
is heard on convection models, verify dimension G
to assure that it is the required depth.
A
H
24" min
I
2"
min
Outlet
Area
20 Amp
Circuit
2"
min
F
G
C
B
36" min
required
17-5/8" distance
to floor
D
Figure 2: Microwave Only
PRODUCT DIMENSIONS
MODEL
A
B
C
D
Convection Microwave Oven
29-13/16
19
24-5/8
23
H
I
CUTOUT DIMENSIONS AND CABINET WIDTH
MODEL
Convection Microwave Oven
F
G
Min.
Max.
Min
Min.
Max.
Min.
28
28-3/8
23
17-3/4
18
30-1/8
All dimensions are in inches (cm).
2
BUILT-IN CONVECTION MICROWAVE INSTALLATION INSTRUCTIONS
NOTES:
1. The base must be capable of supporting 155 pounds
(70 kg).
2. Allow at least 21" (53.3 cm) clearance in front of the
oven for door depth when it is open.
3. Dimension G (cutout depth) is critical to the proper
installation of the built-in oven. If the oven decorative
trim does not lie flush against the cabinet, or if noise
is heard on convection models, verify dimension G
to assure that it is the required depth.
I
2"
min
A
24" min*
Outlet
Area
20 Amp
Circuit
H
F
G
C
3"
min*
B
36" min
required
distance
to floor
17-5/8"
D
* See wall oven
installation instructions
for cutout dimensions
Figure 3: Microwave with Wall Oven
PRODUCT DIMENSIONS
MODEL
A
B
C
D
Convection Microwave Oven
29-13/16
19
24-5/8
23
H
I
CUTOUT DIMENSIONS AND CABINET WIDTH
MODEL
Convection Microwave Oven
F
G
Min.
Max.
Min
Min.
Max.
Min.
28
28-3/8
23
17-3/4
18
30-1/8
All dimensions are in inches (cm).
3
BUILT-IN CONVECTION MICROWAVE INSTALLATION INSTRUCTIONS
NOTES:
1. The base must be capable of supporting 155 pounds
(70 kg).
2. Allow at least 21" (53.3 cm) clearance in front of the
oven for door depth when it is open.
3. Dimension G (cutout depth) is critical to the proper
installation of the built-in oven. If the oven decorative
trim does not lie flush against the cabinet, or if noise
is heard on convection models, verify dimension G
to assure that it is the required depth.
Outlet
Area
20 Amp
Circuit
A
3"
min
C
B
H
36"
G
17-5/8"
F
D
24" min
Figure 4: Microwave Under Counter Top
PRODUCT DIMENSIONS
MODEL
A
B
C
D
Convection Microwave Oven
29-13/16
19
24-5/8
23
CUTOUT DIMENSIONS AND CABINET WIDTH
MODEL
Convection Microwave Oven
F
G
H
Min.
Max.
Min
Min.
Max.
28
28-3/8
23
17-3/4
18
All dimensions are in inches (cm).
4
BUILT-IN CONVECTION MICROWAVE INSTALLATION INSTRUCTIONS
4.
6.
Install Mounting Screws
The serial plate is located along the interior side trim of
the oven and visible when the door is open.
The microwave oven can tip when the
door is open. The mounting screws supplied with the
microwave oven must be installed to prevent tipping of
the microwave oven and injury to persons.
1. The mounting holes in the side trims may be used as
a template to locate the appliance mounting screw
holes (see figure 5).
2. Use the two screws supplied to fix the appliance to
the cabinet.
Mounting Holes
When ordering parts for or making inquiries about your
microwave oven, always be sure to include the model
and serial numbers and a lot number or letter from the
serial plate.
Serial Plate
Figure 5: Mounting Screw Holes
5.
Model and Serial Number Location
Figure 7: Serial Plate Location
Minimum Cutout Overlap
28"
min cutout
1-5/16"
Before You Call for Service
Read the "Before You Call for Service Checklist" and the
17-3/4" "Operating Instructions" in your Use and Care Guide:
it may save you time and expense. The list includes
min
cutout common occurrences that are not the result of defective
workmanship or materials in this appliance.
Refer to your Use and Care Guide for service phone
numbers.
1/8"
15/16"
Figure 6: Minimum cutout overlap
5
MICROONDAS DE CONVECCIÓN INCORPORADO - INSTRUCCIONES DE INSTALACIÓN
LA INSTALACIÓN Y EL SERVICIO DEBEN SER REALIZADAS POR UN TÉCNICO CALIFICADO.
IMPORTANTE: GUARDE ESTAS INSTRUCCIONES PARA USO DEL INSPECTOR ELÉCTRICO LOCAL.
LEA Y GUARDE ESTAS INSTRUCCIONES PARA FUTURA REFERENCIA.
INSTRUCCIONES IMPORTANTES DE
SEGURIDAD
6
PN A068229 05 ev. A (17/08)
Inglés - páginas 1-5
Español - páginas 6-10
Francés- páginas 11-15
MICROONDAS DE CONVECCIÓN INCORPORADO - INSTRUCCIONES DE INSTALACIÓN
ADVERTENCIA
ADVERTENCIA
Peligro de objeto pesado.
A
24" min
I
2"
min
Área de
salida
Circuito de
20 Amp.
H
2"
min
F
G
C
B
17-5/8"
A
B
C
D
29-13/16
19
24-5/8
23
F
G
I
H
Mín.
Máx.
Mín
Mín.
Máx.
Mín.
28
28-3/8
23
17-3/4
18
30-1/8
7
MICROONDAS DE CONVECCIÓN INCORPORADO - INSTRUCCIONES DE INSTALACIÓN
OBSERVACIONES:
I
2"
min
A
C
H
24" min*
Área de
salida
Circuito de
20 Amp.
F
B
G
3"
min*
17-5/8"
D
A
B
C
D
29-13/16
19
24-5/8
23
F
G
I
H
Mín.
Máx.
Mín
Mín.
Máx.
Mín.
28
28-3/8
23
17-3/4
18
30-1/8
8
MICROONDAS DE CONVECCIÓN INCORPORADO - INSTRUCCIONES DE INSTALACIÓN
OBSERVACIONES:
Área de
salida
circuito de
20 Amp
A
3"
min
C
B
H
36"
G
17-5/8"
F
A
B
C
D
29-13/16
19
24-5/8
23
F
G
H
Mín.
Máx.
Mín
Mín.
Máx.
28
28-3/8
23
17-3/4
18
9
1-5/16"
1/8"
15/16"
10
INSTRUCTIONS D'INSTALLATION DE MICRO-ONDES À CONVECTION INTÉGRÉE
L'INSTALLATION ET LE SERVICE DOIVENT ÊTRE REALISÉS PAR UN INSTALLATEUR QUALIFIÉ.
IMPORTANT : CONSERVEZ POUR UNE UTILISATION DE LA PART DE L'INSPECTEUR ÉLECTRIQUE
LOCAL.
LISEZ ET CONSERVEZ CES INSTRUCTIONS POUR UNE RÉFÉRENCE FUTURE.
1. Charpenterie
CONSIGNES DE SÉCURITÉ IMPORTANTES
ATTENTION
11
PN A068229 05 Rev. A (17/08)
English – pages 1-5
Español – páginas 6-10
Français – pages 11-15
INSTRUCTIONS D'INSTALLATION DE MICRO-ONDES À CONVECTION INTÉGRÉE
ATTENTION
ATTENTION
24" min
I
2"
min
A
H
C
2"
min
F
G
B
17-5/8"
D
DIMENSION DU PRODUIT
MODÈLE
A
B
C
D
29-13/16
19
24-5/8
23
F
G
I
H
Min.
Max.
Min
Min.
Max.
Min.
28
28-3/8
23
17-3/4
18
30-1/8
12
INSTRUCTIONS D'INSTALLATION DE MICRO-ONDES À CONVECTION INTÉGRÉE
Remarques :
I
2"
min
A
H
C
F
B
G
17-5/8"
DIMENSION DU PRODUIT
MODÈLE
A
B
C
D
29-13/16
19
24-5/8
23
DIMENSIONS DE LA COUPE ET LA LARGEUR DUMEUBLE
MODÈLE
F
G
I
H
Min.
Max.
Min
Min.
Max.
Min.
28
28-3/8
23
17-3/4
18
30-1/8
13
INSTRUCTIONS D'INSTALLATION DE MICRO-ONDES À CONVECTION INTÉGRÉE
Remarques :
A
3"
min
C
B
H
36"
G
17-5/8"
F
DIMENSION DU PRODUIT
MODÈLE
A
B
C
D
29-13/16
19
24-5/8
23
F
G
H
Min.
Max.
Min
Min.
Max.
28
28-3/8
23
17-3/4
18
14
1-5/16"
1/8"
15/16"
PN:16170000A79791
15