User Manual MN032006EN
Effective May 2018
LED function
Front panel LEDs
When the module is initially connected to power, it performs internal setup and diagnostics checks to determine if it is operating correctly. These checks take approximately 80 seconds. The following table shows how the LEDs appear when the module is operating correctly.
Table 13. Front panel LEDs
LED Condition
RF
RF
RF
RF
RF
232
PWR
PWR
PWR
PWR
PWR
Green
Red
Orange
Fast Flash
Slow Flash
Green
Flash Off from Green
Flash Green from Off
Flash Red from Off
Orange Flash
Green
232
232
Red
Orange
485
485
Green
Red
Meaning
System OK
System boot (initial or system fault)
Start of system boot
System boot, stage 1
System boot, stage 2
RF Link established
Radio Receive
Radio Receive (Good Signal)
Radio Receive (Weak Signal)
Radio transmit
Transmitting RS
-
232 data
Receiving RS
-
232 data
Transmitting and receiving RS
-
232 data
Transmitting RS
-
485 data
Receiving RS
-
485 data
Figure 95. Boot sequence
LEDs
Additional 415U-E LEDs
LED
RPT
ETH
ETH
Condition
Green
Green
Green
Yellow
Green
Solid Yellow
Flash Yellow
Meaning
Strong signal suitable for 64QAM/4FSK
Good signal suitable for 16QAM/4FSK
Weak signal suitable for 4QAM/2FSK
Very weak signal suitable for
4QAMFEC/2FSK
Device is active as a Repeater
Ethernet LINK
Ethernet activity
LED boot sequence
Upon reset, the PWR LED appears solid red for about 2 seconds
(system boot), followed by 12 seconds of Orange (start of system boot process). The PWR LED then fast flashes between red and green for 30 seconds (stage 1 of system boot process) followed by a slow flashes for 50 seconds (stage 2 of system boot process). At the end of the boot sequence the PWR should appear solid green.
The time periods are approximate, and depend on the hardware and firmware revisions.
415U Condor-long-range wireless I/O and gateway
66 EATON
www.eaton.com
