The IGNORE CONDITION command for a given condition applies only to the program in which it is specified, and it remains active while the program is being executed, or until a HANDLE CONDITION command for the same condition is encountered, in which case the IGNORE CONDITION command is overridden.
You cannot include more than sixteen conditions in the same command; the conditions must be separated by at least one space. You may specify additional conditions in further IGNORE CONDITION commands.
Refer to Chapter 6, “Dealing with exception conditions,” on page 87 for more
information.
Options
condition
specifies the name of the condition to be ignored.
ISSUE ABEND
Abend the mapped conversation with an APPC partner.
CONVID(
name
) STATE(
cvda
)
Conditions:
INVREQ, NOTALLOC, TERMERR
Description
ISSUE ABEND abnormally ends the conversation. The partner transaction sees the
TERMERR condition. See part 3 of
CICS for iSeries Intercommunication
for more information.
Options
CONVID(
name
)
identifies the conversation to be abended. The 4-character name identifies the token returned by a previously executed ALLOCATE command in the
EIBRSRCE field of the EIB.
If this option is omitted, the principal facility for the task is used by default.
STATE(
cvda
)
gets the state of the current conversation.
For a complete list of the CVDA values that can be returned on APPC commands and for information about receiving and testing these values, see
“CICS-value data areas (CVDAs)” on page 309.
Exception Conditions
INVREQ
RESP2 values:
200
A distributed program link server application specified the function-shipping session (its principal facility) on the CONVID option.
also occurs (RESP2 not set) in any of the following situations:
374
CICS for iSeries Application Programming Guide V5
