4.3.4 SMTP. Messoa NCC800(WL)

4. Using Web-based Control Utility

4.3.4 SMTP

To enable the camera to send you email notifications when an alarm is triggered, you need to specify an SMTP server to send the emails.

„

My Server Requires Authorization:

If your SMTP server requires authorization to send emails, enable this option.

„

SMTP Server IP:

Enter the IP address of the SMTP server.

„

User Name:

Enter the user name to log on to the SMTP server.

„

Password:

Enter the password to log on to the SMTP server.

„

Sender:

Enter the email address to be shown as the sender of the notification email.

„

Receiver:

Enter the email address to which the notification email is sent.

4.3.5 NTP

If you want the camera to synchronize its time clock with an NTP (Network Time Protocol) sever, configure the NTP server settings here.

„

NTP Server:

Enter the IP address or the domain name of the NTP server to synchronize with.

„

Time Zone:

Select a time zone in which the camera is located.

„

DST - Automatically Adjust for Daylight Saving Time Changes:

Check to apply the daylight saving time automatically if the camera is uesd in an area that is affected by DST. Then specify the month,

36 User Manual