Quick Setup
Connection Diagram
Items not listed under
Introduction
>
Box
Contents
are sold
separately.
Microphones
USB drive
CHARGE
Tablet
Speaker Stand Installation
1.
Fully extend the speaker stand tripod legs on a flat, stable surface. Look in the box contents under the foam sheet for the rubber feet and speaker stand mounting knob.
1
2.
Raise the mounting pole up to the appropriate height needed and tighten the side adjustment knob.
3.
Insert the pin into the bottom pin-hole so the mounting pole stays at your set height.
2
4.
On Total PA Supreme, adjust the bottom knob counterclockwise so the screw is not blocking the opening.
5.
Line up the Total PA Supreme mounting hole with the speaker stand pole and place on the pole.
6.
Tighten the mounting knob clockwise on Total PA Supreme.
3
4
SD Card
5
/
6
Smartphone
Power
4
