advertisement
Meter instructions
Main display
Speed:
Distance:
Time:
Heartrate:
0 – 99
0 - 99.9
0 - 99
50-240 km/h km minutes bpm
1
Lower display
Timer setting:
Distance setting:
Calories:
Only if chestbelt is used
1 - 99
0.1 - 99.9
0-999 minutes km kcal
6
Fig: Display
1) Main display
2) Lower display
3) MODE-key
4) (+) -key
5) (-) -key
6) RESET-key
5
4
3
2
Batteries: 4 x 1.5 V, R14
Storing temperature: -10º C - +60º C
Operating temperature: 0º C - +50º C
Main display
Press any key or move the pedal gives a signal to the meter that activates all functions.
This display shows Speed, Distance, Time and
Heartrate.
As soon as the subject begins pedalling activates the meter and all readings on the display. Time count starts when pedalling begins and Time count stops if pedalling is stopped. Time is only displayed in minutes.
A ”P” in the Heartrate display indicate that the meter has not detected any heartrate signals. The signals comes from a wireless heartrate transmitter/ chestbelt which can be bought as an accessory (Art.
No: 9339-98). The electrodes on the transmitter shall be moistened a little before it is put on the chest.
Moistening the electrodes makes the pulse signal good already from start. The chest belt/transmitter is to be placed just below the chest muscles.
Lower display
The count down function in the lower display window can be set in time or distance - minutes or kilometres.
Press MODE key to activate. Display will then start flashing. While flashing press MODE again and it will change between time and distance. As long as it is flashing the figures can be changed. Use the buttons
(+) or (-) to increase or decrease value. At setting value flashes for 15 seconds. To change setting again activate by press the MODE key. When pedalling starts the count down begins. When reaching zero a beeper sounds.
The calorie consumption shows in the lower display.
Press MODE to change view between time, distance and calories.
NOTE!
To show KCAL in the display you must use chestbelt.
Reset key
Press RESET key to zero Speed and Distance in the main display. An automatic reset is also made after an automatic turn off of the computer.
Km/Miles
For setting of km or miles press MODE until ”km” start flashing. Use the buttons (+) or (-) to change to miles.
Turn off
After two minutes the computer will turn off automatically if there is no speed or HR-signal detected. At an automatic turn off all parameters are set to zero.
Maintenance
Do not expose the meter to direct sunlight or extremely high temperature. Do not use any dissolvents when cleaning. Use only dry cloth.
Monark 927 E
7
advertisement
Related manuals
advertisement