4.3 Pairing Remote Control with Battery. ePropulsion VAQUITA

4.3 Pairing Remote Control with Battery

VAQUITA Remote Control and VAQUITA Battery in each package are well paired prior to delivery, but if: ① the remote is a new one, or ② the battery is a new one, communication will fail and users need to build wireless communication between the remote control and the battery.

Follow below instructions to pair. We strongly recommend you to read and understand all process before implementing pairing operation.

Preparation

Turn off the remote control and turn on the battery.

Entering Pairing Mode

Step 1 Put the Battery into Pairing Mode

① Press the battery power button.

All battery LEDs simultaneously enter slow flash mode. This mode lasts only a few seconds, during which execute

②

, otherwise you have to repeat

①

.

②

Press the battery power button again and hold for about 5s until all

LEDs flash quickly (which indicates the battery has entered pairing mode successfully). Then release the button.

The battery's pairing mode only continues for a limited period of time, so execute step 2 during this period, otherwise pairing fails.

Step 2 Put the Remote Control into Pairing Mode

①

Hold the remote control close to the battery.

②

Press and hold the remote's on/off button for 10s until it issues two beeps (to indicate the remote control has entered pairing mode).

Release the button and you'll hear another beep to indicate pairing succeeds.

Do not release the button within 10s, otherwise pairing fails.

30