ITEM
MODEL
Power Requirement
Power Output
Microwave Frequency
Magnetron
Timer
Outside Dimensions
Cavity Dimensions
Net Weight
Shipping weight
Control Complement
SPECIFICATIONS
DESCRIPTION
M130TCS
230 ~ 240 Volts AC 50 Hz
1,200 Watts
Single phase, 3 wire grounded
800 Watts full microwave power (IEC60705)
2,450 MHz
2M214 - 39F, 2M218J, 2M254J
0 ~ 99 min. 90 sec.
483 (W) x 285 (H) x 360 (D) mm
312 (W) x 198 (H) x 316 (D) mm
12.5 kg (approx.)
14 kg (approx.)
Microwave Power for Variable Cooking
Power level
Max Full power throughout the cooking time
Med.-High approx. 80% of Full power
Medium approx. 60% of Full power
Defrost approx. 40% of Full power
Low/Warm approx. 20% of Full power
Nameplate Location
Back Side
Accessories
Owner's manual & cooking guide
Glass turntable
Rotating Ring
This microwave oven is designed for household use only.
It is not recommended for commercial purposes.
1-1
CAUTIONS
Unlike other appliances, the microwave oven is high-voltage and high-current equipment.
Though it is free from danger in ordinary use, extreme care should be taken during repair.
• DO NOT operate on a 2-wire extension cord during repair and use.
• NEVER TOUCH any oven components or wiring during operation.
• BEFORE TOUCHING any parts of the oven, always remove the power plug from the outlet.
• For about 30 seconds after the oven stops, an electric charge remains in the high voltage capacitor. When replacing or checking, you must discharge the high voltage capacitor by shorting across the two terminals with an insulated screwdriver.
MICROWAVE RADIATION
Personnel should not be exposed to the microwave energy which may radiate from the magnetron or other microwave generating device if it is improperly used or connection.
All input and output microwave connections, waveguide, flange and gasket must be secure never operate the device without a microwave energy absorbing load attached.
Never look into an open waveguide or antenna while the device is energized.
• Proper operation of the microwave oven requires that the magnetron be assembled to the waveguide and cavity. Never operate the magnetron unless it is properly installed.
• Be sure that the magnetron gasket is properly installed around the dome of the tube whenever installing the magnetron.
ANTENNA
Gasket
COOLING FIN
FILAMENT
TERMINALS
MAGNETRON
MAGNETRON
CHASSIS GROUND
• Remove your watches whenever working close to or replacing the Magnetron.
• DO NOT touch any parts of the control panel circuit. A resulting static electric discharge may damage this
P.C.B.
• NEVER operate the oven with no load.
• NEVER injure the door seal and front plate of the oven cavity.
• NEVER put iron tools on the magnetron.
• NEVER put anything into the latch hole and the interlock switches area.
THE OVEN IS TO BE SERVICED ONLY
BY PROPERLY QUALIFIED SERVICE
PERSONNEL.
2-1
