advertisement
VIVOTEK - A Leading Provider of Multimedia Communication Solutions
Software revision upgrade
Customers can obtain the up-to-date software from the web site of VIVOTEK. An easy-to-use Upgrade Wizard is provided to upgrade the Network Camera with just a few clicks. The upgrade function is opened to the Administrator only. To upgrade the system, follow the procedures below.
1. Download the firmware file named “xxx.pkg” from the appropriate product folder.
2. Run the Upgrade Wizard and proceed following the prompts. Refer to the instructions of the Upgrade Wizard for details.
3. Or upgrade firmware from HTTP web page directly
3. The whole process will finish in a few minutes and it will automatically restart the system.
If power fails during the writing process of Flash memory, the program in the memory of the Network Camera may be destroyed permanently. If the Network
Camera cannot restart properly, ask your dealer for technical service.
User's Manual - 21
advertisement
* Your assessment is very important for improving the workof artificial intelligence, which forms the content of this project
Related manuals
advertisement
Table of contents
- 2 Before You Use This Product
- 5 Package Content
- 5 Installation
- 5 Hardware installation
- 8 Software installation
- 9 Initial Access to the Network Camera
- 9 Check Network Settings
- 9 Add Password to prevent Unauthorized Access
- 10 How to Use
- 10 Authentication
- 11 Installing plug-in
- 12 Primary user’s capability
- 12 Main Screen with Camera View
- 13 Digital Zoom
- 14 Snapshot
- 15 Client settings
- 17 Administrator’s capability
- 17 Fine-tuning for Best Performance
- 19 Opening accounts for new users
- 20 Build a security application
- 21 Software revision upgrade
- 22 Definitions in Configuration
- 23 System parameters
- 24 Security settings
- 25 Network settings
- 25 Network type
- 26 RTSP Streaming
- 28 WLAN Configuration
- 31 Access List
- 32 Audio and Video
- 32 General
- 32 Video Settings
- 33 Video orientation
- 33 Audio settings
- 34 Image Settings
- 35 Email & FTP
- 35 Email
- 37 Motion detection
- 38 Application settings
- 38 Snapshot
- 38 Weekly schedule
- 38 Snapshot file name prefix
- 38 Send out the snapshot while motion detection
- 39 Sequential operation
- 39 Method for sending snapshot
- 42 System log
- 43 Viewing system parameters
- 44 Maintenance
- 45 Appendix
- 45 A. Troubleshooting
- 45 Status LED
- 45 Reset and restore
- 45 B. URL commands of the Network Camera
- 46 Get server parameter values
- 47 Set server parameter values
- 48 Available parameters on the server
- 58 Application page CGI command
- 60 Capture single snapshot
- 61 Account management
- 62 System logs
- 62 Configuration file
- 63 Upgrade firmware
- 64 D. Technical specifications