Programming a SalvoSwitching Camera Sequence. Bosch LTC 8600, LTC 8800, LTC 8555

70 | en LTC 8600 | LTC 8800 Series

17.7.2 Programming a SalvoSwitching Camera Sequence

A SalvoSwitching sequence can be used to switch a group of monitors simultaneously as a synchronized group. To program a Salvo sequence, enter the programming mode as described above for a simple camera sequence. By definition, Salvo sequencing involves more than one monitor. An example of a simple Salvo sequence that switches cameras on three (3) monitors simultaneously is shown below:

CAMERA MONITOR DWELL

1 1 SLV

2 2 SLV

3 3 2

7 1 SLV

8 2 SLV

9 3 2

21 1

22 3

23 3

SLV

SLV

2

In general, follow the instructions used for the simple camera sequence (described above), but instead of entering a number of seconds for steps that must switch instantly, enter 61 and press [Enter]. This causes the switcher to automatically change to the salvo abbreviation SLV. Dwell time (in seconds) is entered only when you reach the step containing the last monitor that will be switched within the synchronized group.

Bosch Security Systems, Inc.

Instruction Manual F.01U.127.393 | 2.0 | 2009.03