Chassis setup. Bosch DIP-2042-4HD
Add to my manuals
40 Pages
Bosch DIP-2042-4HD is a powerful network video recorder that offers reliable recording and management of up to 4 HD cameras. With pre-licensed channels, it's an affordable and easy-to-use solution for small to medium-sized businesses seeking a professional surveillance system.
advertisement
16 en | Chassis setup DIVAR IP 2000
4
!
Chassis setup
This chapter covers the steps required to install components and perform maintenance on the chassis.
Caution!
Review the warnings and precautions listed in the manual before setting up or servicing this chassis.
Observe the following prerequisites when adding or replacing hard disks.
Prerequisites:
– DIVAR IP only supports an even number of hard disks (2 or
4)
– Bay 1 and bay 2 must be populated with hard disks
– All hard disks of the unit must have the same capacity
Notice!
Insert the hard disks before initial system start.
4.1
See also:
–
–
Installing a hard drive, page 17
Removing hard drive trays
The drives are mounted in drive carriers to simplify their installation and removal from the chassis. These carriers also help promote proper airflow for the drive bays.
To remove hard drive trays from the chassis:
1.
Turn off the system.
2.
Press the release button on the drive carrier. This extends the drive carrier handle.
3.
Use the handle to pull the drive carrier with the drive out of the chassis.
2014.07 | V1 | DOC Bosch Sicherheitssysteme GmbH
DIVAR IP 2000
4.2
Chassis setup | en 17
4.
Insert the drive carrier with the new drive into the chassis bay, making sure that the drive carrier handle is completely closed.
Notice!
Except for short periods of time, do not operate the unit with the hard drives removed from the bays.
Installing a hard drive
The drives are mounted in drive carriers.
To install a hard drive to the hard drive carrier:
1.
Remove the drive from the carrier.
2.
Install a new drive into the carrier with the printed circuit board side facing down so that the mounting holes align with those in the carrier.
3.
Replace the drive carrier into the chassis bay, making sure that the drive carrier handle is completely closed.
Notice!
We recommend using the respective Bosch hard disk drives.
The hard disk drives as one of the critical component are carefully selected by Bosch based on available failure rates.
HDD – not delivered from Bosch – are not supported.
Information on supported HDDs can be found in the datasheet in the Bosch Online Product Catalog.
Bosch Sicherheitssysteme GmbH 2014.07 | V1 | DOC
advertisement
* Your assessment is very important for improving the workof artificial intelligence, which forms the content of this project
Related manuals
advertisement
Table of contents
- 1 Title Page
- 3 Table of Contents
- 4 Safety precautions
- 4 General safety precautions
- 7 Electrical safety precautions
- 8 ESD precautions
- 9 Operating precautions
- 10 Available documentation
- 11 System overview
- 11 Device views
- 14 LED description - front panel
- 15 LAN port LED description - rear panel
- 16 Chassis setup
- 16 Removing hard drive trays
- 17 Installing a hard drive
- 18 Installation - first steps
- 18 Setup notes
- 18 Connecting the unit
- 20 Obtainging a basic configuration
- 21 Advanced configuration
- 23 Maintaining the system
- 23 Monitoring the system
- 24 Recovering the unit
- 25 Backing up the configuration
- 26 Adding/replacing hard disks
- 26 Extending a 2-disk unit
- 27 Extending an empty unit
- 27 Replacing hard disks
- 28 Updating the system
- 29 Using the IP Helper tool
- 30 End-user license agreement (EULA)
- 39 Back Page