Front Wiper Motor and Link. Caple Wi151

Front Wiper Motor and Link

7. Front Wiper Motor and Link

A: REMOVAL

1) Disconnect the ground cable from battery.

2) Remove the cowl panel. <Ref. to EI-39, RE-

MOVAL, Cowl Panel.>

3) Disconnect the connector of wiper motor assembly.

4) Remove the bolt to remove wiper assembly.

WIPER AND WASHER SYSTEMS

2) When the battery is connected to the terminal of connectors, confirm that the wiper motor operates at high speed.

3 2

5 4

1

WW-00219

3) Connect the battery to terminals of connector, and remove the terminal connection with wiper motor rotated at low speed, and stop the wiper motor through operation.

WW-00217

NOTE:

Wiper motor and wiper link can not be disassembled, because those are assembly part.

B: INSTALLATION

Install in the reverse order of removal.

Tightening torque:

Refer to “COMPONENT” of “General Description”.

<Ref. to WW-2, FRONT WIPER, COMPO-

NENT, General Description.>

C: INSPECTION

1) When the battery is connected to the terminal of connectors, confirm that the wiper motor operates at low speed.

3 2

5 4

1

WW-00220

4) Connect the battery and confirm that the wiper motor stops at automatic stop position after the wiper motor operates at low speed again.

3 2

5 4

1

3 2

5 4

1

WW-00221

WW-00218

WW-15