- Home
- Domestic appliances
- Climate control
- Split-system air conditioners
- Mitsubishi
- TG-2000A
- Instruction manual
advertisement
1 Introduction
A special feature of Mitsubishi Electric Corporation’s “Central Controller G-50A” is that a PC connected to a
LAN can be used to monitor the operation condition of air conditioners, perform air conditioner operations, and make initial settings.
This document explains the procedures for making initial settings for the Central Controller G-50A using the web browser.
1-1 Conventions Used in This Manual
- Unless otherwise specified, "Windows" refers to Windows
®
98, Windows
®
Me, Windows
®
2000 and Windows
®
XP.
Note: Windows is a registered trademark or trademark of Microsoft Corporation USA in the United States and other countries.
- “Click” refers to the action of positioning the mouse cursor on the object (such as button or folder) and pressing down and releasing the left mouse button once.
- Unless otherwise specified, the example screen images used in this manual are Windows XP and Internet
Explorer 6.0 screen images.
1-2 Computer Requirements
In order to monitor and operate air conditioners by web browser, your computer must meet the following requirements.
Table 1-1 Computer Requirements
Item Requirement
CPU Pentium 133MHz or faster (300MHz or faster recommended)
Memory 64M Bytes or more (128M Bytes or more recommended)
Screen resolution
Compatible browser
On-board LAN port or LAN card
1024 x 768 or higher recommended
Microsoft® Internet Explorer 5.0 or later
Note: You must have a Java execution environment
(Microsoft VM Ver5.0 or later or Sun Microsystems Java
Plug-in Ver.1.4.2 or later).
Note: You can check the Microsoft VM version by entering “jview” in a command prompt.
Note: You can check the Sun Microsystems Java Plug-in version in
“Java Plug-in” in a control panel.
One connector (10BASE-T)
Other Pointing device such as a mouse
Note: Microsoft is a registered trademark or trademark of Microsoft Corporation USA in the United States and other countries.
1-3 Notes on using G-50A with Integrated Software (TG-2000A)
If the system is connected to the integrated centralized control software (referred to as TG-2000A hereafter), make all settings and changes from the TG-2000A so that the data in TG-2000A and G-50A will match.
1
advertisement
Related manuals
advertisement
Table of contents
- 2 1 Introduction
- 2 1-1 Conventions Used in This Manual
- 2 1-2 Computer Requirements
- 3 2 Setting the Operating Environment
- 3 2-1 Setting the PC IP Address
- 5 2-2 Setting the Web Browser
- 7 3 Performing Operations
- 7 the G-50A
- 8 4 Initial Settings
- 8 4-1 Setting the Current Date and Time
- 9 4-2 Setting the Basic Information and External Input Functions
- 15 4-3 Group Setting
- 17 4-4 Interlocked Setting
- 18 4-5 Block Setting
- 19 5 Functions
- 19 5-1 Error mail reports/E-mail communication
- 21 5-2 Energy-Save Control and Peak Cut Control
- 25 6 Functions
- 25 6-1 Limiting the Set Temperature Operating Range
- 26 6-2 Night Mode Schedule
- 27 6-3 Auto-Changeover of Y series
- 28 7 User Setting
- 30 8 Registering a License for Optional Function