telephone base. AT&T CL84109 - DECT 6.0, CL84309, CL84109, CL84209

Appendix C

Expansion handset

Adding and registering handsets (optional)

Handsets purchased separately (AT&T CL80109) need to be registered to the telephone base before use. When first purchased, all expansion handsets show NOT REGISTERED on the screen. New handsets may need to be charged without interruption for at least 10 minutes before registering to the telephone base.

NOT REGISTERED

To register a handset to your telephone base

1. Make sure the handset is out of the charger and shows NOT

REGISTERED before you begin registration.

NOT REGISTERED

2.

Press and hold INTERCOM /HANDSET LOCATOR on the telephone base for about four seconds (until the red IN USE light on the telephone base is on) and then release the button, the screen of the telephone base shows REGISTERING...

REGISTERING... The IN USE light remains on while the telephone base attempts to register a handset.

MSG#

--

3. Place the unregistered handset into the charger, PRESS

HNDST LOC 4 SEC ON BASE shows on the handset screen.

The handset is now registering with the telephone base. The handset then shows PLEASE WAIT... and it takes up to 60 seconds to complete the registration. There is a beep sound when the registration is successful. The handset shows

HANDSET X REGISTERED, with X being the handset number

(1-12).

PRESS HNDST LOC

4 SEC ON BASE

PLEASE WAIT...

NOTES:

1. If the registration is not successful, the screen shows NOT REGISTERED. To reset the handset, remove the handset from the charger, then start again from step 2 above.

2. You cannot register a handset if any other system handset is in use.

HANDSET X

REGISTERED

67