Connecting with the PC. Medion GoPal E4x70

22.2. Connecting with the PC

 Press the On/Off button to start your navigation system.

 Connect the USB cable to your navigation system.

 Push the USB connector into a free USB port on your computer.

 The following screen will appear after the navigation system has been connected:

Mass storage mode

ActiveSync® mode

PLEASE NOTE!

The ActivSync® mode will be loaded automatically after a few seconds, if no mode has been selected.

 Select the desired mode:

22.2.1. Mass Storage mode

You will be able to use your navigation device as a detachable device (e.g. a USB stick) in the Mass Storage mode. Two drives, the internal memory of the navigation system itself and the (optional) memory card, if it has been inserted into the device, will be connected to do this.

PLEASE NOTE!

No further entries can be made on the device at the same time if you are in this mode. Use the ‘Remove hardware safely’ function of your operating system to protect yourself against data loss. Now, remove the cable from your navigation system.

The Hardware Installation Assistant will now recognize a new device and will install a suitable driver. This can take several minutes.

68 of 82