advertisement
For # MS-260 U/261 U and # MS-330 U/331 U
Fix the protector (1) to the clamp (3) with two bolts.
For # MS-230 C/231 C, MS-260 C/261 C and MS-330 C/331 C
Fix the protector (1) to the clamp (3) with two bolts.
(3)
(3)
(1)
(1)
MOUNTING OF CUTTER BLADE OR NYLON CUTTER HEAD
Turn the Brush Cutter/String Trimmer upside down and replace the cutter blade or the nylon cutting head.
- Installing Cutter-Blade
Mount the cutter blade (A) onto the receiver washer (B).
Make sure that the cutter blade (A) is centered and lies flat.
The guide of the receiver washer (B) must fit in the arbor hole in the cutter blade (A).
Install the clamp washer (C) with the raised center away from the cutter blade (A).
Insert the holding-pin (D) through the slot of the grass cover (E) and rotate the receiver washer (B) until it is locked with the holding -pin (D). Then install the nut guard (F) and the blade nut (G) onto the gear case and turn counterclockwise to tighten securely.
Note : Always wear gloves when handling the cutter blade
D
B
A
C
F
G
STOP
- Installing Nylon cutting head
Install the receiver washer (A) onto the gear case.
Insert the holding-pin (B) through the slot of the grass cover (C) and rotate the receiver washer (A) until it is locked with the holding-pin (B). Then place the nylon-cutting head (D) on the receiver washer (A) and rotate the nylon-cutting head (D) counterclockwise to tighten securely.
B
A
D
E
C
9
advertisement
Related manuals
advertisement
Table of contents
- 4 SYMBOLS
- 5 SAFETY INSTRUCTIONS
- 7 TECHNICAL DATA
- 8 MOUNTING OF HANDLE
- 8 MOUNTING OF PROTECTOR
- 9 MOUNTING OF CUTTER BLADE OR NYLON CUTTING HEAD
- 10 FUELS/REFUELING
- 10 CORRECT HANDLING OF MACHINE
- 11 POINTS IN OPERATION AND HOW TO STOP
- 11 RE-SHARPENING THE CUTTING TOOL
- 12 SERVICING INSTRUCTIONS
- 13 STORAGE
- 17 SYMBOLES
- 18 CONSIGNES DE SÉCURITÉ
- 20 DONNÉES TECHNIQUES
- 22 ASSEMBLAGE DE LA POIGNÉE
- 22 ASSEMBLAGE DU PROTECTEUR
- 23 OU DE LA TÊTE DE COUPE EN NYLON
- 24 CARBURANTS/REMPLISSAGE
- 24 COMMENT TENIR L'OUTIL
- 25 ET FAÇON D'ARRÊTER L'OUTIL
- 26 INSTRUCTIONS POUR LA RÉPARATION
- 27 RANGEMENT
- 31 SÍMBOLOS
- 32 INSTRUCCIONES DE SEGURIDAD
- 34 DATOS TÉCNICOS
- 36 MONTAJE DEL ASIDERO
- 36 MONTAJE DEL PROTECTOR
- 37 MONTAJE DEL DISCO O EL CABEZAL DEL CORDÓN DE NYLON
- 38 COMBUSTIBLE/REPOSTAJE
- 38 MANEJO CORRECTO DE LA MÁQUINA
- 39 EN LA OPERACIÓN Y CÓMO PARAR
- 39 AFILADO DEL IMPLEMENTO DE CORTE
- 40 INSTRUCCIONES DE MANTENIMIENTO
- 41 ALMACENAMIENTO