Safety. Ariens 932037 - 724, 932505 - 724, 932038 - 5520, 932507 - 520, 932039 - 624, 932508 - 624

DISCLAIMER

Ariens reserves the right to discontinue, make changes to, and add improvements upon its products at any time without public notice or obligation. The descriptions and specifications contained in this manual were in effect at printing. Equipment described within this manual may be optional. Some illustrations may not be applicable to your unit.

DELIVERY

Customer Note: If you have purchased this product without complete assembly and instruction by your retailer, it is your responsibility to:

1. Read and understand all assembly instructions in this manual. If you do not understand or have difficulty following the instructions, contact your nearest Ariens

Dealer for assistance. Make sure all assembly has been properly completed.

NOTE: To locate your nearest Ariens Dealer, call 1-920-756-4688 or go to www.ariens.com on the internet.

WARNING: Improper assembly or adjustments can cause serious injury.

2. Understand all Safety Precautions provided in the manuals.

3. Review control functions and operation of the unit. Do not operate the Sno-Thro unless all controls function as described in this manual.

4. Review recommended lubrication, maintenance and adjustments.

5. Review Limited Warranty Policy.

6. Fill out a Product Registration Card and return the card to the Ariens Company or go to www.ariens.com.

SAFETY

WARNING: To avoid injury to hands and feet, always disengage clutches, shut off engine, and wait for all movement to stop before unclogging or working on snow thrower.

Hand contact with the rotating impeller is the most common cause of injury associated with snow throwers. Never use your hand to clean out the discharge chute.

Keep hands and feet away from auger and impeller.

SAFETY ALERTS

Look for these symbols to point out important safety precautions.

They mean:

Attention!

Personal Safety Is

Involved!

Become Alert!

Obey The Message!

The safety alert symbols above and signal words below are used on decals and in this manual. Read and understand all safety messages.

WARNING: POTENTIALLY

HAZARDOUS SITUATION! If not avoided, COULD RESULT in death or serious injury.

CAUTION: POTENTIALLY

HAZARDOUS SITUATION! If not avoided, MAY RESULT in minor or moderate injury. It may also be used to alert against unsafe practices.

NOTATIONS

NOTE: General reference information for proper operation and maintenance practices.

IMPORTANT: Specific procedures or information required to prevent damage to unit or attachment.

PRACTICES AND LAWS

Practice usual and customary safe working precautions, for the benefit of yourself and others. Understand and follow all safety messages. Be alert to unsafe conditions and the possibility of minor, moderate, or serious injury or death. Learn applicable rules and laws in your area. Always follow the practices set forth in this manual.

DANGER: IMMINENTLY

HAZARDOUS SITUATION! If not avoided, WILL RESULT in death or serious injury.

GB - 5

REQUIRED OPERATOR TRAINING

Original purchaser of this unit was instructed by the seller on safe and proper operation. If unit is to be used by someone other than original purchaser; loaned, rented or sold,

ALWAYS provide this manual and any needed safety training before operation.

SAFETY DECALS AND

LOCATIONS

ALWAYS replace missing or damaged Safety

Decals. Refer to figure below for Safety Decal locations.

1

08095700A

DANGER/PELIGRO

ROTATING PARTS

Stop engine and remove ignition key before clearing. ONLY use clean-out tool to clear blockages. NEVER use your hands.

PIECES EN ROTATION

Arreter le moteur et retirer la clé de contact avant le débourrage. N'utiliser QUE des outils de nettoyage pour désobstruer. NE

JAMAIS utiliser les mains.

PIEZAS GIRATORIAS

Detener el motor y sacar la llave antes de despejar. Para limpiar obstrucciones se debe usar SOLAMENTE una herramienta adecuada. NUNCA se debe hacerlo con las manos.

08093901

2

DANGER / PELIGRO

ROTATING PARTS

Keep clear of auger while engine is running.

PIECES EN ROTATION

Ne pas s'approcher du rotor lorsque le moteur est en marche.

SAFETY

• Read operator's manual.

• Allow operation only by properly trained adult, never children.

• Stop engine and remove ignition key prior to leaving operator's position for any reason.

• Keep all controls, guards and safety devices properly serviced and functional.

• Never direct discharge towards persons or property that may be injured or damaged by thrown objects.

Mantenerse alejado del sinfín mientras que el motor esté en marcha.

SÉCURITÉ SEGURIDAD

• Lire le manuel du l’opérateur.

• Seuls les adultes ayant recu la formation appropriée peuvent utiliser la machine, jamais les enfants.

• Toujours arrêter le moteur et retirer la clé de contact avant de quitter le siège de l'opérateur.

• Les commandes, protections et dispositifs de sécurité doivent toujours être correctement entretenus et en bon état de fonctionnement.

• Ne jamais orienter la goulotte d'évacuation vers des personnes pour

éviter tout risque de blessure par des objets projetés ou vers des bâtiments pour éviter de les endommager.

• Leer el manual del operador.

• Permitir la operación sólo por adultos entrenados, nunca niños.

• Parar el motor y sacar la llave de la ignición antes de dejar el puesto del operador por cualquier motivo.

• Mantener todos los controles, protectores y dispositivos de seguridad correctamente y en buen funcionamiento.

• Nunca dirigir la descarga hacia personas que puedan lesionarse o propiedad que pueda dañarse por los objetos arrojados.

08094000A

3

1. WARNING!

Read Owner/Operator Manual.

Figure 3

OS2440

OL0910

Never direct discharge towards persons or property that may be injured or damaged by thrown objects.

OL1801

ONLY use clean-out tool to clear blockages. NEVER use your hands.

OL4370

Keep people away from unit while operating. Keep children out of work area and under watchful care of a responsible adult.

Wear appropriate hearing protection.

OL4690

OL4010

Stop engine, remove key, read manual before making any repairs, adjustments.

GB - 6

2. DANGER!

OS6610

ROTATING PARTS! ONLY use clean-out tool to clear blockages.

NEVER use your hands. High speed impeller rotates below discharge opening. Wait for all moving parts to stop before removing clogs or servicing.

3. DANGER!

OS2080

ROTATING PARTS.

Keep clear of auger while engine is running.

• Read Operator’s Manual.

• Allow operation only by properly trained adult, never children.

• Stop engine and remove ignition key prior to leaving the operator’s position for any reason.

• Keep all controls, guards and safety devices properly serviced and functional.

• Never direct discharge towards persons or property that may be injured or damaged by thrown objects.

SAFETY RULES

Read, understand, and follow all safety practices in Owner/Operator Manual before beginning assembly or operating. Failure to follow instructions could result in personal injury and/or damage to unit.

ALWAYS remove key and/or wire from spark plug before assembly, maintenance or service.

Unintentional engine start up can cause death or serious injury.

Complete a walk around inspection of unit and work area to understand:

• Work area • Your unit • All safety decals

ALWAYS check overhead and side clearances carefully before operation. ALWAYS be aware of traffic when operating along streets or curbs.

Keep children and people away. Keep children out of work area and under watchful care of a responsible adult.

NEVER allow children to operate or play on or near unit. Be alert and shut off unit if children enter area.

DO NOT allow adults to operate unit without proper training.

Keep area of operation clear of all toys, pets, and debris. Thrown objects can cause injury.

Check for weak spots on docks, ramps or floors. Avoid uneven work areas and rough terrain. Stay alert for hidden hazards.

Avoid uneven and rough terrain. DO NOT operate near drop-offs, ditches, or embankments. Unit can suddenly turn over if a wheel is over the edge of a cliff or ditch, or if an edge caves in.

Falling snow, fog, etc. can reduce vision and cause an accident. Operate unit only when there is good visibility and light.

Only trained adults may operate unit.

Training includes actual operation.

NEVER operate unit after or during the use of medication, drugs or alcohol. Safe operation requires your complete and unimpaired attention at all times.

NEVER allow anyone to operate this unit when their alertness or coordination is impaired.

DO NOT operate unit without wearing adequate winter outer garments. Wear adequate safety gear, including safety glasses with side shields, and protective gloves. Wear proper footwear to improve footing on slippery surfaces.

DO NOT wear loose clothing or jewelry and tie back hair that may get caught in rotating parts.

Protect eyes, face and head from objects that may be thrown from unit. Wear appropriate hearing protection.

Avoid sharp edges. Sharp edges can cut.

Moving parts can cut off fingers or a hand.

ALWAYS keep hands and feet away from all rotating parts during operation. Rotating parts can cut off body parts.

NEVER place your hands or any part of your body or clothing inside or near any moving part while unit is running.

ALWAYS keep hands away from all pinch points.

DO NOT touch unit parts which might be hot from operation. Allow parts to cool before attempting to maintain, adjust or service.

GB - 7

Never direct discharge towards persons or property that may be injured or damaged by thrown objects. Use extreme caution on gravel surfaces. Stay alert for hidden hazards or traffic. Adjust Runners so Scraper Blade does not contact gravel.

DO NOT throw snow any higher than necessary.

Deflected materials can cause injury and property damage.

Always stand clear of the discharge area when operating this unit.

Fumes from engine exhaust can cause injury or death. DO NOT run engine in an enclosed area. Always provide good ventilation.

ALWAYS disengage attachment, stop unit and engine, remove key and allow moving parts to stop before leaving operator’s position.

ROTATING IMPELLER CAN CAUSE

SERIOUS INJURY. NEVER ATTEMPT TO

UNCLOG OR CLEAN UNIT WHILE ENGINE

IS RUNNING.

Read, understand, and follow all instructions in the manual and on the machine before starting.

Understand:

• How to operate all controls.

• The functions of all controls.

• How to STOP in an emergency.

Before starting engine, disengage control(s).

Use only approved extension cords and receptacles when starting units equipped with electric starter. DO NOT connect electric starter cord to any wiring system that is not a three-wire grounded system.

ALWAYS allow unit and engine to adjust to outdoor temperatures before clearing snow.

Always be sure of your footing, especially when operating in reverse or leaving the operator’s position. Walk, never run during operation.

DO NOT overload the machine capacity by attempting to clear snow at too fast a rate.

DO NOT operate at too fast a rate.

Slow down and turn corners slowly.

Do not operate in reverse unless absolutely necessary. ALWAYS back up slowly. Always look down and behind before and while backing.

Disengage attachment drive when traveling from one work area to another.

Abnormal Vibrations are a warning of trouble.

Striking a foreign object can damage unit.

Immediately stop unit and engine. Remove key and wait for all moving parts to stop.

Remove wire from spark plug. Inspect unit and make any necessary repairs before restart.

Before cleaning, removing clogs or making any inspections, repairs, etc.: disengage clutch(es), stop unit and engine, remove key, allow moving parts to stop. Allow hot parts to cool.

Run unit a few minutes after clearing snow to prevent freeze-up of attachment.

Disengage attachment when not in use.

Disengage all clutches before starting engine.

Adjust runners to clear gravel or crushed rock surfaces safely.

Never leave a running unit unattended.

ALWAYS shut off engine before leaving unit.

ALWAYS remove key to prevent unauthorized use.

Never carry passengers.

Check clutch and brake operation frequently.

Adjust and service as required. All motion of drive wheels and auger/impeller must stop quickly when control levers are released.

DO NOT operate on steep slopes. DO NOT clear snow across the face of slopes. Keep all movement on slopes slow and gradual. DO

NOT make sudden changes in speed or direction. Use a slow speed to avoid stops or shifts on slopes. Avoid starting or stopping on a slope.

DO NOT park unit on a slope unless absolutely necessary. When parking on a slope always block the wheels.

ALWAYS shut off engine, remove key, and close fuel shut-off valve or drain fuel when transporting unit on a truck or trailer.

Use extra care when loading or unloading unit onto trailer or truck.

Secure unit chassis to transport vehicle.

NEVER secure from rods or linkages that could be damaged.

DO NOT transport machine while engine is running.

Keep unit free of ice or other debris. Clean up oil or fuel spills.

GB - 8