advertisement
Attach Handles
The handles attach to the same end of the generator as the feet. To attach the handles to the generator, perform the following steps:
1. Place one handle onto the upper portion of the generator frame as shown in figure 3.
2. Slide handle with M8 × 40 bolts attached through the hole and secure using an M8 nut.
3. Repeat steps 1 and 2 for the other side.
At this point, gently remove the two wheels from underneath the generator.
a b
Figure 3- handle assembly
Attach Wheels
To attach the wheels to the generator, perform the following steps:
1. Find a wood block or similar item that is 3 inches thick or greater and rest the exhaust end of the generator on the block as shown in figure 4.
2. Take one wheel shaft, and one M12 nut as shown. Slide the wheel shaft, with the threaded part facing inward, through the frame. Secure using an M12 nut and the included wrench as shown in figure 5.
3. Slide the wheel onto the axle and secure in place using a large cotter pin as shown in figure
6. Spread the pin legs apart slightly to help secure the pin in place.
4. Repeat steps 2 and 3 for the other wheel.
At this point, the generator assembly is complete. Gently remove the generator from the wood block.
11
a b
Figure 4- supporting the generator Figure 5- axle assembly a b
CAUTION: Only this side toward AXLE. c
Figure 6- wheel installation
12
advertisement
* Your assessment is very important for improving the workof artificial intelligence, which forms the content of this project
Related manuals
advertisement
Table of contents
- 2 GENERATOR MODEL NUMBER: ____________________________________
- 2 ENGINE SERIAL NUMBER: _________________________________________
- 3 TABLE OF CONTENTS
- 6 WARNING: The exhaust from this product contains chemicals known to the State of California to cause cancer, birth defects, or other reproductive harm.
- 13 Attach Feet
- 14 Attach Handles
- 14 Attach Wheels
- 16 Using the Generator for the First Time
- 16 Step 1 - Fill Oil
- 17 Step 2- Add Gasoline
- 18 Step 3- Ground the Generator
- 19 WARNING: This generator produces powerful voltage, which can result in electrocution.
- 21 Step 1- Check the Oil
- 21 Step 2 – Check the Gas Level
- 21 Step 3- Ground the Generator
- 23 AC Usage
- 26 DC Usage
- 27 Cleaning the Generator
- 27 Checking the Oil
- 28 Changing/ Adding Oil
- 29 Air Cleaner Maintenance
- 29 Fuel Filter Cup Cleaning
- 30 Spark Plug Maintenance
- 30 Draining the Fuel Tank
- 40 FOR WEN POWERTM GENERATORS