Specifications. Dixon ZTR 4500 Series

SPECIFICATIONS

Model ZTR 4515, 4516 & 4518

Chassis:

Body:

Twin 12 gauge side frames and 7 gauge transmission and engine base plate.

All body parts made of high density polyethylene. Dent and corrosion resistant.

Mower Deck:

Blade Drive:

Transmission:

42” Deck: 13 GA stamped steel construction-42” cut width

50” Deck: 11 GA fabricated construction/reinforcement ribs-

50” cut width

Electric clutch.

Each rear wheel is independently driven by a Hydro Gear IZT hydrostatic drive.

Engine:

Model 4515:

Model 4516:

15.5 HP Briggs & Stratton Vanguard, 4 cycle, single cylinder, overhead valve, air cooled, gasoline, vertical cast iron cylinder, pressure lube w/spin-on filter.

16 HP Kohler Command 460 cc, single cylinder, overhead valve, air cooled, gasoline, full pressure lube with oil filter, vertical shaft, aluminum head & block with cast iron cylinder liner.

Model 4518: 18 HP Kohler Command, twin cylinder, overhead valve, air cooled, gasoline, full pressure lube with oil filter, vertical shaft, aluminum head & block with cast-iron cylinder liners.

Starting System: Electric-key switch operation w/safety interlock blade drive.

Tires: Front 11 x 4.00-5 ribbed tread (16-21 PSI)

Rear 18 x 8.50 x 8 4 ply turf tread (8-14 PSI)

Capacities: Fuel

Engine Oil

Dimensions: Width

Height

Length

Weight

2.7 gallons

B&S 1.5 quarts

Kohler 2 quarts

44” maximum track width

42” to top edge of seat

72” hitch tab to front bumper power unit: 463 lbs with 42” deck 547 lbs with 50” deck-603 lbs

Note: Additional information provided in service instructions under the individual component.

SPECIFICATIONS SUBJECT TO CHANGE WITHOUT NOTICE.

14