Diagnostic Program. Marantz DR6000

OTHER INFORMATIONS

The numbers between parentheses refer to the fold-out.

Player does not react

• use the POWER ON/OFF (1) button on the front of the

Player to switch it off and back on

on display

• a power failure has occurred during recording the CD-

Recorder is attempting to repair the disc

• If then appears on the display, the disc cannot be recorded further, and cannot be finalized. But it can still be played on the CD-Recorder or another CD-

Recorder.

• on a CD-R(W) disc, the track being recorded is lost, but further recording and finalisation can still be done

POWER ON/OFF

CD RECORDER DR6000

Recordable

ReWritable

OPEN/CLOSE

DISPLAY SCROLL

SOURCE ERASE STORE

MENU

CANCEL

DELETE

FINALIZE

REC TYPE REW FF

STOP

EASY JOG

REC

PUSH ENTER qwe w w

Diagnostic Program

If the malfunction continues, perform the Diagnostic Program:

1 Switch the recorder off using the POWER ON/OFF (1).

2 Simultaneously press the R (18) and Q (19) and switch the recorder back on using the POWER ON/OFF (1).

➔ The display will now indicate ‘ ’.

➔ After a few minutes, the message will change to

➔

‘

If the

’ or ‘ ’.

message appears, your recorder is defective and needs to be repaired. Consult your supplier or call the Marantz Consumer Line to find the nearest service centre. The number of the Consumer Line can be found in the guarantee booklet.

➔ If the ‘ ’ message appears, there is no clear defect and the malfunction may be a result of misinterpretation of the user instructions, an inappropriate disc, a mechanical defect or an incorrect connection. To solve this problem, carefully read the user instructions once again; you can also contact your supplier.

➔ If you cannot solve the problem, go to the nearest service centre.

3 Switch off the recorder using the POWER ON/OFF (1) to exit from the Diagnostic Program.

Downloaded From Disc-Player.com Marantz Manuals

20