advertisement
12
CLEANING AND STORAGE
1. After use, fill the Glass Pitcher 1 /
3
full with clean water and run one of the Pre-Programmed
Buttons to remove most of food debris remaining in the Glass Pitcher.
NOTE: If necessary you may add a couple of drops of dish soap.
2. Empty the Glass Pitcher.
3. Repeat Step 1 and Step 2 with the Glass Pitcher 2 /
3
full of clean warm water with NO SOAP
to rinse the pitcher thoroughly.
4. Empty the Glass Pitcher.
5. Dry the Glass Pitcher fully for the next use.
NOTE: If any food debris remains at the blade assembly area, remove the Blade Assembly using the Blade Opener provided to clean out the debris. (Please see “How to Remove
Blade Assembly from the Glass Pitcher” page 13.)
Motor Base
1. Unplug the power cord.
2. Wipe the outside surface with a damp cloth or sponge. Do not use abrasive cleaners
on the Motor Base.
3. Dry with a soft cloth or paper towel.
4. The rubber feet on the bottom of the Motor Base will keep the blender from moving
on most work surfaces. Clean the rubber feet regularly. When the rubber feet are dirty,
the machine may move on the counter.
WARNING: Do not immerse the Motor Base in water.
How to Clean the White Silicone Seal
When you take out the Blade Assembly, you will see a white Silicone Seal placed on the inside ridge of the Glass Pitcher. Clean it and keep it in a safe place, then replace when reassembling the Blade Assembly and the Glass Pitcher. (Please see “How to Reassemble the Blade Assembly” page 13.)
How to Remove Blade Assembly from the Glass Pitcher
1. Turn the Glass Pitcher upside down.
2. Align ridges on the Blade Opener
to the grooves on the Blade
Assembly (as shown in Green).
3. Unlock the Blade Assembly by turning
the Blade Opener counter-clockwise.
4. Make sure to see whether the Blade
Assembly has been released from
the locked position to unlocked
position (as shown in Orange).
5. Cover the bottom of the Glass
Pitcher with your palm and turn
the Glass Pitcher right side up.
The Blade Assembly will slowly fall
into your palm.
WARNING: The blade is sharp. Do not touch to avoid cutting yourself. Do not leave it in soapy water where it may not be visible.
NOTE: Additionally, you may use the inside of the Lid as a blade opener.
Align the inside of the Lid Cap opening with the Blade Assembly and turn counter-clockwise.
Locked
Unlocked
How to Reassemble the Blade Assembly
1. Place the Silicone Seal at the ridge of the
Glass Pitcher.
2. Place the Blade Assembly in its place over the
Silicone Seal and turn it clockwise to its locked
position using the Blade Opener.
STORAGE
1. Keep your Tribest ® Dynablend ® ready for use on the kitchen counter.
2. Keep it unplugged when it is not in use.
3. If you keep your Blade Assembly disassembled, please store it in a convenient, safe
place out of the reach of children, as you would with sharp knives.
13
advertisement
Related manuals
advertisement
Table of contents
- 6 Important Safeguards
- 8 Standard Parts
- 9 Names of Parts
- 10 Before First Use
- 11 Operation Instructions
- 12 Cleaning and Storage
- 14 Warranty
- 16 Parts and Optional Accessories
- 17 Recipes
- 30 Product Standard
- 18 I. Smoothies/Blended Drinks
- 21 III. Sweet or Savory Sauces
- 23 V. Dressing
- 24 VI. Tapenade/Pesto
- 25 VII. Porridge
- 26 VIII. Pâté
- 27 IX. Pudding
- 28 X. Baby Food
- 29 XI. Possible Nutritional Supplements