advertisement
DSL-504G ADSL Router User’s Guide
LAN IP Settings
You can configure the LAN IP address to suit your preference. Many users will find it convenient to use the default settings together with DHCP service to manage the IP settings for their private network. The IP address of the Router is the base address used for DHCP. In order to use the Router for DHCP on your LAN, the IP address pool used for DHCP must be compatible with the IP address of the Router. The IP addresses available in the DHCP IP address pool will change automatically if you change the IP address of the Router. See the next section for information on DHCP setup.
To access the LAN Settings menu, click the LAN button in the Home directory.
Configure LAN IP settings
To change the LAN IP Address or LAN Network Mask, type in the desired values and click the Apply button.
The new IP settings must be saved and the Router must be restarted for the settings to go into effect. To Save &
Reboot the Router, click on the Tools directory tab and then click the Misc (Miscellaneous) menu button. In the
Miscellaneous menu, click the Save & Reboot button. The Router will save the new IP settings and restart. Your web browser should automatically be redirected to the new IP address. The new IP settings will be applied upon restarting.
30
advertisement
* Your assessment is very important for improving the workof artificial intelligence, which forms the content of this project
Related manuals
advertisement
Table of contents
- 9 About This User’s Guide
- 9 Before You Start
- 9 Installation Requirements
- 12 Introduction
- 12 Router Description and Operation
- 13 Router Features
- 14 Front Panel Display
- 15 Rear Panel Connections
- 16 Hardware Installation
- 16 Power on Router
- 16 Factory Reset Button
- 17 Network Connections
- 18 Power On Router
- 18 Factory Reset Button
- 19 Basic Router Configuration
- 19 Configuring IP Settings on Your Computer
- 26 Access the Web Manager
- 27 Using the Web Manager
- 28 Using the Setup Wizard
- 33 Configure WAN Connection
- 34 PPPoE and PPPoA Connection for WAN
- 35 Bridged Connection for WAN
- 36 Dynamic IP Address for WAN Connection
- 37 Static IP Address for WAN Connection
- 38 LAN IP Settings
- 39 DHCP Server Settings for the LAN
- 40 Use the Router for DHCP
- 40 Use the ISP’s DHCP Server
- 40 Disable the DHCP Server
- 41 DNS Server Settings
- 42 Save New Settings
- 43 Advanced Configuration/Network Management
- 45 Virtual Server
- 47 Filters
- 49 Firewall
- 50 Static Routing
- 52 ADSL Modulation Settings
- 52 PPP Settings
- 53 ATM VC
- 54 Multiple Virtual Connections
- 56 Tools and Utilities
- 56 Change System Password
- 57 Configure System Time
- 58 Save Router Configuration Settings
- 59 Save Configuration File to PC
- 59 Load Saved Configuration Files
- 59 Restore Factory Default Settings
- 60 Firmware Upgrade
- 61 Router Status Information
- 61 Device Information Display
- 64 Technical Specifications
- 66 Low Pass Filters