- Computers & electronics
- Computer components
- System components
- Motherboards
- DFI
- G586IPE
- User's manual
advertisement
![Supervisor Password. DFI G586IPE, G586IPV | Manualzz Supervisor Password. DFI G586IPE, G586IPV | Manualzz](http://s1.manualzz.com/store/data/001505571_1-80448d3a90940f342b3b917a14fe075e-360x466.png)
Enabled
Disabled
The IDE controller card is designated as the secondary IDE controller.
No IDE controller card occupying any of the PCI slots.
Onboard FDD Controller
Enabled
Disabled
Enables the onboard floppy disk controller.
Disables the onboard floppy disk controller.
Onboard Serial Port 1 and Onboard Serial Port 2
Auto
3F8/IRQ4
2F8/IRQ3
3E8/IRQ4
2E8/IRQ3
Disabled
Selects an address for the onboard serial port 1 and serial port 2.
Disables the onboard serial port 1 and serial port 2.
Onboard Parallel Port
378H/IRQ7
3BCH/IRQ7
278H/IRQ5
Disabled
Selects the I/O address and IRQ for the onboard parallel port.
Disables the onboard parallel port.
Onboard Parallel Mode
SPP
EPP/SPP
ECP
ECP/EPP
Selects the parallel port mode according to the type of printer device connected to your onboard parallel port.
Supervisor Password
If you want to protect your system and setup from unauthorized entry, set a supervisor’s password with the “System” option selected in the
BIOS Features Setup.
37
advertisement
Related manuals
advertisement
Table of contents
- 4 Chapter 1: Introduction
- 4 Features and Specifications
- 5 Package Checklist
- 6 Chapter 2: Hardware Installation
- 6 Board Layout
- 7 System Memory
- 9 Cache Memory
- 9 CPU Installation
- 16 Jumper Settings for CMOS Clear
- 16 Jumper Settings for Display Type
- 17 Built-in Ports
- 20 Installing Expansion Cards
- 21 Chapter 3: Software Installation
- 21 Award BIOS CMOS Setup Utility
- 22 Standard CMOS Setup
- 26 BIOS Features Setup
- 30 Chipset Features Setup
- 31 Power Management Setup
- 34 PNP/PCI Configuration Setup
- 35 Load BIOS Defaults
- 35 Load Setup Defaults
- 36 Integrated Peripherals
- 37 Supervisor Password
- 38 User Password
- 39 IDE HDD Auto Detection
- 41 HDD Low Level Format
- 41 Save & Exit Setup
- 41 Exit Without Saving
- 42 System Error Report
- 43 IDE Device Drivers
- 44 Appendix A: Types of Modules
- 45 Appendix B: Memory and I/O Maps
- 47 Appendix C: Connector