Commands. Mintek DTV-323-D, SCENIUM L32WD14

Using the Remote Control

Therefore, after you’ve successfully set up the Volume Punchthrough feature, whenever the TV remote is in DVD mode (press the DVD button) and you want to adjust the volume, you only have to press the VOL +/- or MUTE buttons. Follow the instructions below to set up Volume

Punchthrough.

1. On your remote control, simultaneously press and hold the ON•OFF and MUTE buttons

(approximately 3 seconds) until a device button remains lit. Then release the buttons.

2. Press and hold the MUTE button until the device button blinks off, then release the MUTE button.

3. Press and release the device button that you programmed to operate the audio system

(receiver or amplifi er).

4. Press and release the MUTE button.

5. Now, test it by turning on your audio system.

6. Turn on the device that is connected to the audio system (satellite receiver, for example).

7. Put the TV’s remote in SAT•AUX mode by pressing the SAT•AUX button.

8. Press VOL+ or VOL-. The volume from the audio system should increase or decrease accordingly.

Deleting ALL Volume Punchthrough Commands

To delete all programmed Volume Punchthrough settings and return the remote control back to the factory defaults:

1. Simultaneously press and hold the ON•OFF and MUTE buttons (approximately 3 seconds) until a device button remains lit. Then release the buttons.

2. Press and hold the MUTE button until the device button blinks off, then release the MUTE button.

3. Press and release the MUTE button until the device button light turns off.

4. The remote returns to normal Volume/Mute control.

Chapter 2 23