Location. Miele F 7102 S

Installation

Appliances without side wall heating must not be installed "side-by-side" next to another refrigerator or freezer.

Do not place any appliance which gives off heat, such as a toaster or microwave oven, on top of this appliance, as this would increase the appliance's energy consumption.

The appliance will function perfectly down to a temperature of +5 °C.

Ventilation

Air at the back of the appliance gets warm. To ensure sufficient ventilation, the ventilation grilles must not be covered over. The air inlet and outlet must not be covered or blocked in any way. They should be dusted on a regular basis.

Location

It should not be installed where it is exposed to direct sunlight or directly adjacent to a heat-producing appliance such as an oven or a radiator. The appliance should be installed in a dry well-ventilated room.

The higher the ambient temperature of the room the more energy the appliance requires to operate.

Installation

^ Remove any cable clips from the back of the appliance.

^ Check that all parts at the back of the appliance are unhindered. Remove any hindrance.

^ Carefully push the appliance into position.

Aligning the appliance

Climate range

The appliance is designed for use within certain climate ranges (ambient temperatures), and should not be used outside this range. The climate range of this appliance is stated on the data plate inside the appliance.

Climate range

SN

N

ST

T

SN-ST

SN-T

Ambient room temperature

+10 °C to +32 °C

+16 °C to +32 °C

+18 °C to +38 °C

+18 °C to +43 °C

+10 °C to +38 °C

+10 °C to +43 °C

^ To align the appliance, adjust the feet using the spanner supplied.

29

Changing the door hinging

The appliance is supplied right-hand hinged. If left-hand door hinging is required follow these instructions.

^ Use the spanner supplied to unscrew upper hinge pin d and refit it on the other side.

^ Remove stoppers f, and unscrew handle e. Refit the handle on the other side of the door.

^ Then refit stoppers g on the opposite side of the door.

^ Hang the door on the upper hinge pin and close the door.

^ Fit hinge bracket b in the lower door bearing. Then screw it securely to the appliance plinth.

Use the long slots in the hinge bracket to align the door. Make sure you have tightened all screws properly.

^ Close the appliance door, unscrew hinge bracket b, and take the door off.

^ Take hinge pin c out of the hinge bracket, then refit it in the second hole in the hinge bracket. (Use the spanner supplied to unscrew and refit the hinge pin).

^ Remove cover a and use it to cover the now empty holes on the opposite side.

30

31

Alteration rights reserved / 4604

F 1313 S

M.-Nr. 06 154 980 / 02