Appendix D – Making changes to the program INI file. Sensorsoft ST6105J
Add to my manuals
42 Pages
advertisement
Sensorsoft Remote Watchman Express/Client User Manual
Appendix D – Making changes to the program INI file
The table below documents some of the program variables that can only be changed by editing the rwmx.ini or rwmc.ini file. The following procedure shows how to make changes to these variables:
1. Stop the RWMX or RWMC program.
2. Open the rwmx.ini or rwmc.ini file using Windows Notepad. This can usually be done by double-clicking on the file name. This file is located in root installation directory or the instance directory.
3. Locate the variable you wish to change and modify its value (see the table below for reasonable values).
4. Save the rwmx.ini or rwmc.ini file and restart the RWMX or RWMC program. The new settings will now take effect.
Variable Name
SensorStartDelay 0 to 5 Delay in seconds before the program starts to communicate with the SSD. This is intended to allow the SSD to power-up before any commands are sent to it. Using 0 disables the delay. parameters used in sending pager messages. The default parameters of 1200,e,7,1 are used by most PSP’s. The alternate parameters of
1200,n,8,1 are used by some
PSP’s outside of North America.
WebServerLogFileLinesLimit Maximum number of log file lines returned by the Sensorsoft
Web Server.
SMTP_RemotePort The default of 25 is the wellknown port used by most mail servers. If you have configured your own mail server to a port other than 25, this is where you configure the RWMC SMTP mail client.
1200,n,8,1
1 to 10000
25 to 65000
42
advertisement
* Your assessment is very important for improving the workof artificial intelligence, which forms the content of this project
Related manuals
advertisement
Table of contents
- 4 About This Manual
- 4 Glossary of Acronyms
- 5 Overview
- 6 System Requirements
- 7 Installation Procedure
- 7 Removal Procedure
- 8 Starting the Software
- 8 Connecting to your first Sensorsoft device (SSD)
- 9 Configuring the Software
- 9 Sensor Tab
- 12 Audio Alerts Tab
- 13 Pager Alerts Tab
- 16 Run Command Tab
- 18 Pop-up Alerts Tab
- 19 E-mail Alerts Tab (RWMC Only)
- 21 Setting up an E-mail Event (RWMC Only)
- 22 Log Files Tab
- 24 HTML Page Tab
- 25 Web Server Tab (RWMC Only)
- 26 Running the software as a separate User under Windows XP
- 27 Creating Multiple RWMX/RWMC Instances
- 28 Removing Selected RWMX/RWMC Instances
- 29 Viewing Statistics
- 31 Remotely Viewing HTML Pages and Log Files (RWMC only)
- 31 Configuring the Sensorsoft Web Server
- 31 Setting up the HTML Page
- 32 Connecting your Web Browser to the Sensorsoft Web Server
- 33 Frequently Asked Questions
- 34 Troubleshooting Error Messages
- 37 Getting Help
- 37 Technical Support
- 37 30 Day Money Back Guarantee
- 37 Returns
- 38 Appendix A – Pager Tutorial
- 40 Appendix B – Modem DIP switch settings
- 41 Appendix C – Using Dollar ($) Variables in your messages
- 42 Appendix D – Making changes to the program INI file