Troubleshooting. BenQ W600, W600 DLP, 600, W600 - 720p DLP Projector

Troubleshooting

The projector does not turn on.

Cause

There is no power from the power cable.

Remedy

Plug the power cord into the AC inlet on the projector, and plug the power cord into the power outlet. If the power outlet has a switch, make sure that it is switched on.

Wait until the cooling down process has completed.

Attempting to turn the projector on again during the cooling process.

No picture

Cause

The video source is not turned on or connected correctly.

The projector is not correctly connected to the input signal device.

The input signal has not been correctly selected.

Remedy

Turn the video source on and check that the signal cable is connected correctly.

Check the connection.

Select the correct input signal with the

SOURCE key on the projector or remote control.

Blurred image

Cause

The projection lens is not correctly focused.

The projector and the screen are not aligned properly.

Remote control does not work

Cause

The battery is out of power.

There is an obstacle between the remote control and the projector.

You are too far away from the projector.

The password is incorrect

Cause

You do not remember the password.

Remedy

Adjust the focus of the lens using the focus ring.

Adjust the projection angle and direction as well as the height of the unit if necessary.

Remedy

Replace the battery with new one.

Remove the obstacle.

Stand within 7 meters (23 feet) of the projector.

Remedy

Please see

"Entering the password recall procedure" on page 27 for details.

58 Troubleshooting