Applicable standards and reference documentation. Seagate HAWK 2 ST12400W/WD/WC

Add to My manuals
82 Pages

advertisement

Applicable standards and reference documentation. Seagate HAWK 2 ST12400W/WD/WC | Manualzz

2 Product Manual - Hawk 2 Family (Wide bus) SCSI-2 (Volume 1), Rev. A

_____________________________________________________________________________________

2.0

Applicable standards and reference documentation

The drive has been developed as a system peripheral to the highest standards of design and construction.

The drive depends upon its host equipment to provide adequate power and environment in order to achieve optimum performance and compliance with applicable industry and governmental regulations. Special attention must be given in the areas of safety, power distribution, shielding, audible noise control, mechanical mounting and temperature regulation.

2.1

Standards

The ST12400 Wide SCSI bus drive family complies with Seagate standards as noted in the appropriate sections of this specification and the Seagate SCSI-2/SCSI-3 Interface Specification, P/N 77738479 (Vol. 2,

Version 2).

The ST12400 wide family is a UL Recognized component per UL 1950 and a CSA Certified component per

CAN/CSA-C22.2 No. 950-M89. It also meets the requirements of DIN VDE 0805/05.90 and EN60950: 1988

(IEC 950).

The ST12400 wide family drives, as delivered, are designed for system integration and installation into a suitable enclosure prior to use. As such the ST12400 wide family drives are supplied as a sub-assembly and are not subject to Subpart J of Part 15 of the FCC Rules and Regulations nor the Radio Interference Regulations of the Canadian Department of Communications. However, the units have been tested using proper shielding and grounding and found to be compliant with Class A limits of the FCC Rules and the Regulations of The Canadian Department of Communications.

The physical design characteristics of the ST12400 wide family serve to minimize radiation when installed in an enclosure that provides reasonable shielding. As such, the ST12400 wide is capable of meeting the Class

B limits of the FCC Rules and Regulations of the Canadian Department of Communication. However, it is the users responsibility to assure that the ST12400 wide meets the appropriate EMI requirements in their system. Shielded I/O cables may be required if the enclosure does not provide adequate shielding. If the I/O cables are external to the enclosure, shielded cables should be used, with the shields grounded to the enclosure and to the host controller.

Caution.

To avoid potential service problems, observe the following precautions:

2.2.

The Manufacturers installed labels must not be removed from the drive or covered with additional labels, as they contain information required when servicing the product.

Applicable reference documents

Installation Guide

Product Manual - SCSI-2/SCSI-3 Interface

Seagate P/N 77767465

Seagate P/N 77738479

ANSI Small Computer System Interface (SCSI): Document Number ANSI3.131-1986 (X3T9/84.40 Rev. 1B)

(X3T9.2/82-2 Rev. 17B), X3T9.2/86-109 Revision 10H (SCSI-2) and X3T9.2/92-184 Rev. 4 (SCSI-3).

Package Test Specification Seagate P/N 30190-001 (under 100 lbs.)

Package Test Specification Seagate P/N 30191-001 (over 100 lbs.)

In case of conflict between this document and any referenced document, this document shall take precedence.

advertisement

Related manuals

advertisement

Table of contents