Remote “DC In” Control. Monster Power PRO 3600, 109199-00

HOOK-UP GUIDE

Remote “DC In” Control Hook-Up

This feature connects your PRO 3600 PowerCenter to an automated Home Theater control system or allows another component with a Remote “DC Out” connection to automatically turn on and off your PRO 3600 PowerCenter.

A) Plug the AC power cable of the component you are using to control the PRO 3600 PowerCenter into properly grounded AC outlet. Note: This component must deliver a control voltage between 3-30 volts DC.

B) Plug one end of the 1/8" miniplug (supplied) into the corresponding Remote “DC In” connection on the PRO 3600 PowerCenter.

C) Plug the other end of the 1/8" miniplug into the Remote “DC Out” connection on the component that you want to turn on and off the PRO 3600 PowerCenter when it is turned on.

D) Set Remote/Normal switch to Remote.

14

Remote “AC In” Control Hook-Up

This feature connects your PRO 3600 PowerCenter to an automated Home Theater control system or allows another component with an AC outlet connection (for example, an AV receiver or preamplifier for example) to automatically turn on and off your PRO 3600 PowerCenter.

A) Insert the Remote “AC IN” Control cord’s female plug into the “AC IN” 120V connection.

B) Insert the Remote “AC IN” Control cord’s 2-prong male plug into a switched AC power outlet on the component

(AV receiver or preamplifier). When this device is turned on, the outlets programmed as “Switched On” on the PRO 3600 PowerCenter will turn on immediately. The outlets programmed as “Switched On After Delay” will turn on after the set time delay.

C) Set Remote/Normal switch to Remote.