Opening & Closing Digital Safe. First Alert 2 Cu. Ft. Digital Executive Safe

5

Opening & Closing Digital Safe

OPENING SAFE WITH PASSCODE & KEY

OPENING THE SAFE

Once your passcode has been entered into the memory, the safe can be opened by following these simple steps:

1

Insert one of the Companion Entry Keys (round top) into the lock cylinder but DO NOT TURN KEY.

2 Press the * button on the keypad, followed by the the safe for the first time) and the # button.

3

The LCD display will read "Good" and you will hear a tone indicating that the safe door is unlocked.

4 To open, turn the Companion Entry Key (round top) to the RIGHT and turn the handle.

NOTE: You must open the safe door within 3 seconds or the electronic lock automatically engages.

To program personal passcode, follow steps 1-4 on page 3.

IMPORTANT:

TURN ENTRY KEY TO RIGHT ONLY

Turning it to the left may cause key to become stuck in the cylinder and may cause damage to the lock.

CLOSING THE SAFE

1

2

3

4

5

Make sure the key is in the open position.

Close the door.

The handle will automatically return to the closed position.

Turn the key all the way to the left.

Remove the key from the lock.

MASTER OVERRIDE CODE USE

The Master Override Code can be obtained from our Consumer Affairs Department.

It can be used to gain entry to your safe in the event that you forget your Passcode.

1

2

3

4

Press the * button on the keypad and the LCD displays "Open".

Within 10 seconds, enter the 8-digit Master Override Code followed by #.

After one minute time delay, LCD displays "Good" along with a melody.

Within 4 seconds, turn the key to the right to open the safe.

NOTE: You must open the safe door within 3 seconds or the electronic lock automatically engages.

Additional Features: Removable Shelves

REMOVABLE SHELVES

ADJUSTABLE & REMOVABLE SHELVES

These models are designed with 5 position adjustable shelves to allow greater flexibility and further accommodate your particular security storage needs.

TO INSTALL:

Your shelf and shelf support clips have been shipped inside your safe and wrapped for protection from damage during shipping.

1

Remove shelf and (4) shelf support clips from protective wrapping.

2

Determine the desired position of your shelf and note the corresponding support guide slots (2 on each side of interior walls) that are best suited to support the shelf in that position.

3

Install the (4) shelf support clips in the same position on all four support guides.

4

Install shelf into position by placing it inside the safe (tilting if necessary) at a point above the desired position.

5

Once inside, lower it into position until resting on shelf support clips.

SUPPORT

GUIDES

ADJUSTABLE & REMOVABLE SHELVES

Simply remove the shelf and reposition the (4) shelf support clips by sliding them up and out of the support slots and reinstalling them into the new positions. Then reinstall shelf as described above.

IMPORTANT:

REMOVING SHELF

If you remove the shelf, it is strongly recommended that you DO NOT DISCARD it.

You may lay the shelf flat in the bottom of the safe to assure full flexibility in the future.

6